Page 1 of 1
MFI X bar and linkages WANTED
Posted: Sun Oct 07, 2007 8:17 pm
by veryporky
Dear all,
After a spare set of MFI linkages and X bar to anodise. If anybody has a set that has already been done sitting around so much the better......
Posted: Sun Oct 07, 2007 9:34 pm
by johnM
Hi Keith
the mfi links were made from mild steel so you can not anodise them, the ones that are available from Henry at supertech have mild steel sockets and aluminium anodised rods, I had to replace my cross bar and found that these were still available from Porsche, it may be helpful to look at this thread.
http://www.ddk-online.com/phpBB2/viewtopic.php?t=16879
Regards
Posted: Mon Oct 08, 2007 8:26 am
by Alan @ CanfordClassics
If it helps and you need them quicker than buying direct I have a lot of the supertech products in stock.
Alan
MFI X Bar & Linkages
Posted: Mon Oct 08, 2007 7:58 pm
by butzsi
Keith,
I have crossbars that have been replated (Passivated zinc finish).Send me a pm if you would like one on exchange.
Regards..........Chris
Posted: Mon Oct 08, 2007 8:20 pm
by johnM
Hi There are a couple of differant types of MFI crossbar just make sure you get the correct one.
911 110 073 00
901 110 057 00
Regards