Page 1 of 1
356 floor pan pictures required
Posted: Thu Jan 11, 2007 12:26 pm
by rupert the bay
anyone got any decent pics of 59 356 floorpans.....either in car, under car or just pans themselves
much appreciated for anything you find
the more.....the better
cheers folks
Posted: Thu Jan 11, 2007 1:40 pm
by Rustbucket
not sure if its a '59 one?
heres some off restoration designs site:
http://www.restoration-design.com/index.html
Dan
PS I got mine from here- they are good
Posted: Thu Jan 11, 2007 2:55 pm
by cubist
Ditto that Rusty
Posted: Thu Jan 11, 2007 3:36 pm
by rupert the bay
cheers fella
think i might have a go at re-producing some
should be a laugh
Posted: Thu Jan 11, 2007 3:47 pm
by 912uk
That p19 pic you can see the lower bowls I have cut out of the sheet I have... so the rest is spare. I was going to cut it up and use the metal but would consider selling it if this helps you out..
Posted: Thu Jan 11, 2007 5:30 pm
by Rustbucket
I think the only difference is the pressing at the toe panel end, something to do with the circle being different.
Posted: Fri Jan 12, 2007 2:39 pm
by rupert the bay
912uk wrote:That p19 pic you can see the lower bowls I have cut out of the sheet I have... so the rest is spare. I was going to cut it up and use the metal but would consider selling it if this helps you out..
how much you looking for ....
i`m very poor and have to rebuild my 356 using only sheet steel a hammer , chisel and wood, please bare this in mind
Posted: Mon Jan 22, 2007 1:32 pm
by Rustbucket
heres mine.............
Posted: Mon Jan 22, 2007 4:27 pm
by rupert the bay
you got any more pics rust bucket, of the rear too ?
Posted: Mon Jan 22, 2007 6:11 pm
by Rustbucket
I have some pics online at:
www.themodelmaker.co.uk
under ' custom vehicles', scroll down to the porsche. I have more/ better ones somewhere, poss online, so I will dig em out..