Page 1 of 1
SWB 911/912 seat belt mounting?
Posted: Sun Dec 17, 2006 10:43 pm
by KS
The 912 is home – looks bootifull! Bruce did an amazing job. BUT journey home reminded me that I want more than lap belts... It's not obvious at all, but anyone tell me where the top mounting hole is for lap and diagonal seat belts? Photo would be much appreciated. Can't see any obvious place without probing holes all over vinyl...
Posted: Sun Dec 17, 2006 11:39 pm
by 912uk
This has been cover a few times with the likes of Pelican parts etc
The 356 way which is similiar is behind on the inner wing.. I think from memory you might need to dig out an old issue of " Porsche 911 world " do you know it..
where the Red 912 was give new seat belts from memory and they were welded in ( a base plate )
Now the correct way for later cars is up on the pillar but you would have to do some research on this to make sure you have a secure fitting..
I have a 3 point belt in my car and I am looking to add recoil seat belts to the car at a later date.. ( 3 points are easy to fit but a bit of apain I found them abit of an asre on the way down to Le Mans this year
Any photo's let me know
I have the 911 world artical as well in my to keep pile..
Glad you got the car sorted now... was abit of a bargain
Posted: Mon Dec 18, 2006 4:38 pm
by MdR
Mark
Can I get a copy of that article?
Posted: Mon Dec 18, 2006 5:49 pm
by Nick Moss
Posted: Mon Dec 18, 2006 6:52 pm
by KS
Thanks Nick!
Posted: Mon Dec 18, 2006 7:19 pm
by 912uk
That will be it..
Nick has all early cars go that there as I was going to weld a backing plate in on my 65 car.
Posted: Mon Dec 18, 2006 8:29 pm
by Nick Moss
That's where they should be, but most are rusted away. My '66 car was the same.
Posted: Tue Dec 19, 2006 9:36 am
by MdR
nick-moss wrote:That's where they should be, but most are rusted away.
That's why my car has the 4 point harness. The factory mount had rusted away. Does anyone have any info on retro fitting 3 point mounts (front and rear) to a SWB car?
Posted: Wed Dec 20, 2006 11:18 pm
by 912uk
MdR wrote:Mark
Can I get a copy of that article?
PM me your address and then nag me in a few weeks when I haven't done it..
I can photo copy it for you.. ( is that ok KS
copy write and all that.. )
Posted: Thu Dec 21, 2006 12:38 am
by KS
912uk wrote:MdR wrote:Mark
Can I get a copy of that article?
PM me your address and then nag me in a few weeks when I haven't done it..
I can photo copy it for you.. ( is that ok KS
copy write and all that.. )
Who cares!!!
Posted: Thu Dec 21, 2006 10:27 am
by 912uk
