type 4 914 engine stuff pork shroud stuff
Posted: Tue Dec 05, 2006 12:51 pm
3 901 fan rings -all stock and uncut -£50 each
-will swap or buy one thats cut for 260mm
-plus i need a fan and an alternator -not fussed if its a pre 74 external alternator, as long as it has the regulatoring devise
pair of cb performance inlet fanny molds, 45mm orifice on inlet, and tall
-i want some 40mm inlet orifice and short sell £60
bas pork coolio type 4 shroud, was black, painted white undrilled sparky plug holes, undrilled for head monting £100
914 cast -closed oil filler and black fuel pump boss -pro cut for porky fan ring
-i need a bus case cut the same -or will sell £100 -has head studs
1700cc 914 engine w code, i have cut the tower off the inlet valves are rusty, and there is no rocker gear - or flywheel £100
2 litre bus engine, now i may use this -long engine £200
i am desperate for a cut ring, as i can now cut my 2 litre for another shroud i have, using the pro cut case i have as a guide
-don't yet need the fan or alt
will take a pair of 2 litre 40mm carbd dell or weber -filters and a linkage
a csp one or any rear case mount turkey twizzler
i have one 40mm drla -aa late one with 32mm vents -£100 -clean
-or may buy a reasonably priced pair of 45 carbs -yeai know i won't
-will swap or buy one thats cut for 260mm
-plus i need a fan and an alternator -not fussed if its a pre 74 external alternator, as long as it has the regulatoring devise
pair of cb performance inlet fanny molds, 45mm orifice on inlet, and tall
-i want some 40mm inlet orifice and short sell £60
bas pork coolio type 4 shroud, was black, painted white undrilled sparky plug holes, undrilled for head monting £100
914 cast -closed oil filler and black fuel pump boss -pro cut for porky fan ring
-i need a bus case cut the same -or will sell £100 -has head studs
1700cc 914 engine w code, i have cut the tower off the inlet valves are rusty, and there is no rocker gear - or flywheel £100
2 litre bus engine, now i may use this -long engine £200
i am desperate for a cut ring, as i can now cut my 2 litre for another shroud i have, using the pro cut case i have as a guide
-don't yet need the fan or alt
will take a pair of 2 litre 40mm carbd dell or weber -filters and a linkage
a csp one or any rear case mount turkey twizzler
i have one 40mm drla -aa late one with 32mm vents -£100 -clean
-or may buy a reasonably priced pair of 45 carbs -yeai know i won't