Page 1 of 2

horn fitment

Posted: Tue Nov 14, 2006 7:39 pm
by petric
hi has anyone any idea or pics of how the twin horns are mounted in the front arch somthings can be hard to work out when they have been in bits for so long peter

Posted: Wed Nov 15, 2006 10:02 am
by jamie
In my car they were screwed to a bracket in front of the nearside front wheel arch. Very easy to get to if you just turn the wheel all the way around to the right.

Posted: Wed Nov 15, 2006 10:15 am
by Helen
presuming they are the same as the 912. then as Jamie says they are mounted on a bracket just behind each horn grill.

easier to get to if you can raise the car up.


not got a picture showing the fitment but have got a picture of the horns
Larry took them out to clean them :roll: spot the clean one
Image

Posted: Wed Nov 15, 2006 10:23 am
by jamie
That's odd - mine had two, both mounted behind only the nearside horn grille. Bitsa alert.

Posted: Wed Nov 15, 2006 10:26 am
by Helen
this is from the short wheel based 912 so maybe the 911 is diffrent ? i haven't looked. :oops:

Posted: Wed Nov 15, 2006 2:14 pm
by early_911
These might help
Image

Posted: Wed Nov 15, 2006 2:14 pm
by early_911
Image

Posted: Wed Nov 15, 2006 5:04 pm
by PhilGarner
Started driving to the MOT station the other say and realised the horn no longer worked. Only 34 years before failure! Very poor. Had to buy one for a mercedes from GSF to get it passed. Is a horn a horn or you think originality important here? :lol:

Posted: Wed Nov 15, 2006 5:31 pm
by Helen
( i just know im going to regret asking this but) whats the bottle for above the horn?

Posted: Wed Nov 15, 2006 5:34 pm
by Helen
PhilGarner wrote:Started driving to the MOT station the other say and realised the horn no longer worked. Only 34 years before failure! Very poor. Had to buy one for a mercedes from GSF to get it passed. Is a horn a horn or you think originality important here? :lol:
well if you want to be excepted into the PCGB elite concourers then im afraid horn deffinatly matters :wink: :lol:

Posted: Wed Nov 15, 2006 5:35 pm
by Bertroex
That should be the windscreen washer bottle, I should guess :?:

Unless of course it is a special undercarriage cleaning equipment that is installed at each corner to spray an agent, under pressure, the arches and ancilliries clean.... :roll:
(hello and yes im back!)

best regards,

Bert

Posted: Wed Nov 15, 2006 5:39 pm
by Helen
ah you mean the special porsche designed rabbit guts removing washer bottle.

:lol:

Posted: Wed Nov 15, 2006 6:06 pm
by Lightweight_911
The plastic 'bottle' is part of the fuel tank vapour venting system.

Posted: Wed Nov 15, 2006 7:46 pm
by Bertroex
Helen wrote:ah you mean the special porsche designed rabbit guts removing washer bottle.

:lol:
Quite, but these guts do always leave a trace in the towing eye. Therefore, the system requires an extension which, no doubt, will be provided in version 3.0. :alien: :wink:

Posted: Wed Nov 15, 2006 8:00 pm
by petric
thanks guys i thought id lost some kind of plate as two horns and one bracket was becoming a bit of a puzzle sorted now thanks (till the next thing i forget how it goes should make notes or pics to keen to pull them to bits ) thanks again peter