Page 1 of 1
Sourcing Weber IDA fuel inlet fibre washers
Posted: Thu Sep 07, 2006 4:24 pm
by MdR
As I don't really need a full carb rebuild kit, where can I get just the fibre(?) washers that seal the banjo unions from?
Posted: Thu Sep 07, 2006 4:51 pm
by roger
Martin
I've got a bag full of Weber washer/gaskets. Can you give me some dimensions and I'll see what the garage can yield!
Posted: Thu Sep 07, 2006 5:27 pm
by MdR
Thanks Roger.
Next question - to save me disturbing my already weeping 40IDA3C fuel inlet banjos can anyone tell Roger the sizes I need?!?
Posted: Thu Sep 07, 2006 5:30 pm
by Gary71
I've also got a few. Halfords do them if you get really stuck!
Posted: Thu Sep 07, 2006 7:19 pm
by Gilbert '71 T
I had the same problem once and got some from my local motor factors for my old Zeniths
Posted: Thu Sep 07, 2006 10:55 pm
by roger
Martin
I'm afraid the memory is playing tricks - got just one fibre washer and stacks of gaskets - sorry
Posted: Fri Sep 08, 2006 12:05 am
by Alan @ CanfordClassics
I have some, I prefer to use copper ones there so have some fibre ones if needed.
Posted: Mon Sep 11, 2006 5:29 pm
by MdR
Thanks one and all.
Alan, can I buy your fibre ones?
Posted: Mon Sep 11, 2006 5:46 pm
by Alan @ CanfordClassics
Hi Martin,
No need to buy them, just send me your address and I will forward some.
Cheers
Alan
Posted: Tue Sep 12, 2006 1:54 pm
by MdR
Yay! Thanks Alan. I'll buy you a pint somewhen.
Posted: Tue Sep 12, 2006 7:39 pm
by Alan @ CanfordClassics
hmmm and I love beer, in fact I am on my second now
Posted: Fri Sep 15, 2006 8:27 am
by Airhead
I been looking for some of these too. Perhaps a few more than required but Frost do them in both Metric and Imperial.....
here's the page in their catalogue