DDK - Die Deutschen Klassiker

Calling all you porsche guru's...

I am building a porsche fan conversion on my 62 split bus and need a top pulley that would fit a 5 blade fan assy...

I presume it is similar to 356 or vw split pulley with shims... not sure...Help...

Has anyone got one spare kicking around that they would part with for cash???

I also need a steel wheel in 5 x 130 stud pattern as a spare.. again if you have one and you no longer need it please let me know...

Cheers

Scott

Is it just the pulley half you want or the bit that's rivetted to the fan too? I may have the outer half knocking about. Its worn but works OK.

Not sure, should the belt rub against the fan and half a pulley?if so then I have the fan part and I need the bit you have.

This is the bit I have:

[img][img]http://i69.photobucket.com/albums/i44/s ... nblade.jpg[/img][/img]


Is your bit all I need plus some shims??

Regards

Scott

Not sure if mine will fit. Mine's for a 69-73 car. Part 901-603-421-01. I haven't got my PET handy but if your fan is 5 fin I think they're from later (77?) Don't know if they'll work together. Maybe someone does?

can anyone help???

PM me your address and I'll put it in the post. If you can use it send me a fiver.

sdog911 - I've sent you a PM about this. Can you sort it out please.

Hi sdog 911,

I've got a 5 blade fan (powdercoated red), shims, and pulley half. Only bit I haven't got is the 'washer' that fits between the alternator shaft nut and pulley half.

Also have an alternator....

pm if interested, and I can send you some photos. Was hoping to sell as a job lot.

regards
Robster

Hi,

An early pulley will not work on that fan as the number of pully holes is different. I am not sure if the same upgrade is required for a VW but it might be worth upgrading the fan to a 11 blade one. It will run cooler



Here is an early 11 blade one on a 2.4T motor



Alan