Page 27 of 27
Re: 912/6 Project - on the rolling road today!
Posted: Tue Nov 10, 2015 2:24 pm
by KS
impmad2000 wrote:There is a setting that does "decel cut" that can give an aggressive stumble on power- off . Might be worth finding this and at 1st, turn it off, if that cures it, re-adjust the parameters at which it cuts in/ out.
Whatever, drive it whilst the weather is mild ! You've got some catching up to do to make up for missed miles
Ah, that makes sense. Might also account for the stumbling in on-off throttle situations in heavy traffic. I'll take a look.
And as for your other suggestion,m you're right!
Thanks for all your help and support!!!
Re: 912/6 Project - on the rolling road today!
Posted: Tue Nov 10, 2015 5:23 pm
by KS
Re: 912/6 Project - here we go again!
Posted: Thu Jul 28, 2016 7:26 pm
by KS
Well, after having what I believed to be cam chain tensioner failure, and then replacing the tensioners with pressure-fed tensioners, and having them 'fail', we've discovered the mystery noise was nothing to do with the tensioners – it's a broken valve spring (inlet on #3)!!!
Don't ya just love cars?
Re: 912/6 Project - here we go again!
Posted: Thu Jul 28, 2016 9:10 pm
by Darren65
Re: 912/6 Project - here we go again!
Posted: Thu Jul 28, 2016 9:32 pm
by 911hillclimber
What a pain that is as a lot has to come off the engine.
Good luck with it.
Re: 912/6 Project - here we go again!
Posted: Thu Jul 28, 2016 10:19 pm
by KS
911hillclimber wrote:What a pain that is as a lot has to come off the engine.
Good luck with it.
Not too bad - compressed air into cylinder. Can be done with engine in the car if needs be, but will drop engine to give better access, though. Shame Bob's not around to comment.
Re: 912/6 Project - here we go again!
Posted: Thu Jul 28, 2016 10:54 pm
by 911hillclimber
Indeed, and have seen the compressed air trick done but not on a 911.
Re: 912/6 Project - here we go again!
Posted: Fri Jul 29, 2016 8:21 am
by Bootsy
Hope it all goes well - not needed as you were just finding your mojo at CLM
Re: 912/6 Project - here we go again!
Posted: Fri Jul 29, 2016 9:05 am
by sladey
Bummer - but on the plus side at least you've found the problem - it'll be great when it's fixed
