DDK - Die Deutschen Klassiker

There was a LOT of fettling to get to this point, lots of filing and marking, filing and marking




Sent from my iPad using Tapatalk Pro

On to the Radio.



I know popular culture would have you believe that “measure twice, cut once” is the way to go but I tend to favour the “measure once, cut loads of times and swear a lot”. It’s not for everyone but it works for me.


Sent from my iPad using Tapatalk Pro

After a suitable amount of filing and swearing




Sent from my iPad using Tapatalk Pro

And in place



As a Brucey bonus I found that if I cut the tabs off the heater chrome surround, it fitted fairly well on top of the black one - with a bit of glue it will be good to go I reckon


Sent from my iPad using Tapatalk Pro

Then with the material glued in place



Sent from my iPad using Tapatalk Pro

Next it was on to the other air vent. Now with the drivers one it was part of a continuous run of ally strip so it had a clear place to sit. For the passenger one it would sit on its own - but it still needed to be framed by the ally.

I thought about this for a while and decided to glue a strip to it top and bottom. I also decided to turn the strip sideways so there was a bit of a ‘tail’ there to give a bigger glueing area.

As luck would have it, the ‘rails’ of the strip aren’t the same size in both profiles so I therefore had to hand file them down the to correct thickness




Sent from my iPad using Tapatalk Pro

And in place on the vent





Sent from my iPad using Tapatalk Pro

During the sanding of the vent itself I realized I needed a disc or belt sander so added another toy to the workshop



This made it much easier to get it to the right thickness


Sent from my iPad using Tapatalk Pro

So then onto the glovebox door....

I took two goes to cover the top part - eventually using a former to help





Sent from my iPad using Tapatalk Pro

When covering the door the material folds over the edge of the ally strip. I didn’t want this to add to the width of the thing so I marked out the thickness of the material


Then carefully filed it away by hand...


Sent from my iPad using Tapatalk Pro

Sent from my iPad using Tapatalk Pro

Et voila



Sent from my iPad using Tapatalk Pro

Finally nearly there



I’ve still had a few gotchas - the fit between the glovebox door and the pad underneath is so tight that if you cover it in black vinyl the door wont open properly.

I took off the covering and it worked fine. I’ve now ordered two of the knee pads in black

It’s been a massively complex job overall - so many little things to sort out but ultimately I’m really pleased with how it’s turned out. I’ll post another pic once I’ve got the new knee pads in place





Sent from my iPad using Tapatalk Pro

Nice work Mark, the attention to detail is really good.

Good grief! Is there no end to your ingenuity/imagination/skills/determination? Great work, Mark.