DDK - Die Deutschen Klassiker

coomo wrote: ↑Sun Feb 08, 2026 5:43 pm

Tedri Mark wrote: ↑Fri Jan 30, 2026 10:16 am Had a quick nose around the inner fender rails earlier - I've been using a photogrammetry app on my phone called KIRI Engine combined with Blender for a couple of things recently, and thought I'd get this section as a 3D model so I can plan how I'm going to repair it:





The fender rail is only curved in one direction - from the top you can see that it is a straight line:


So I'm thinking I either make it by welding together 3 sections:


Or using a shrinker/stretcher to make the main angle of 1&2, and then either weld the small lip (3) onto that, or make some sort of wooden form and try to try to hammer it over.

You can get the top inner wing section from RD.The lower section is taken up with the inner repair panel.You will need to fab the middle section,same as i did on my build.You can hammer the curve or wheel it.A bit tough to try to stretch with a stretcher,as its a tough profile[][/img]