Page 2 of 2
Re: Getting the headlight out
Posted: Wed Jun 17, 2020 10:56 am
by gridgway
Yes indeed, I'm going to go with a non weld solution as I don't have the skilz!
Re: Getting the headlight out
Posted: Wed Jun 17, 2020 4:48 pm
by 911hillclimber
Indeed, no welding is good if you can.
Never heard of the clip-on nuts (chimney) before. Another school day for me.
I had one original tab come off when bending it which led to a few more issues, some rust there does not help, hence welding it. The Dansk tabs look even more fragile.
Many ways to skin a cat!
Re: Getting the headlight out
Posted: Wed Jun 17, 2020 4:58 pm
by PeterK
gridgway wrote:Yes indeed, I'm going to go with a non weld solution as I don't have the skilz!
No skilz hasn’t stopped me going for it so far
Sent from my iPhone using Tapatalk
Re: Getting the headlight out
Posted: Tue Jul 07, 2020 11:42 am
by gridgway
To conclude this, I tried to use the "chimney nuts" that I got, but it wasn't a good solution as there is not enough clearance on the locating tab to fit one. Also it means grinding off the back of the tab which is punched out for the thread (if that makes sense).
So I tried tapping this pushed out part back a little bit, put a tap through it and hey presto a thread again. I don't think it's a very resilient solution, but if it fails, I'll probably have a nut welded to the back of the tab in the future.
Graham