Page 2 of 7
Posted: Wed Dec 05, 2007 9:21 am
by Thomas L
The right side is now cleaned off, only a small amount of rust in the targa reinforcement area.
Is this factory premium welding ?
Targa reinforcement before :
And after....
Im beginning to see the end now.....
Left side is next
Regards Thomas
Posted: Wed Dec 05, 2007 10:20 am
by Vic Cohen
Fascinating , had a couple of Tragas over many years , never seen that end of the Targa bar before ....................
Posted: Mon Dec 17, 2007 9:50 am
by Thomas L
The progress is not fast at the moment, its christmas, but still I have some time to work on the old car....
Hope to be ready for blasting start of january
Regards Thomas
Posted: Mon Dec 17, 2007 11:03 am
by dugsud
Thomas L wrote:

Nice work
Looking at the rot around the base of that roll bar it makes you wonder how many older targas are running around with totally ineffective roll-over protection though

Its christmas and I am finished scraping sealing off....
Posted: Wed Dec 26, 2007 9:21 am
by Thomas L
Posted: Fri Jan 11, 2008 3:03 pm
by Thomas L
Posted: Sat Jan 12, 2008 10:46 am
by Barry
Very nice, Thomas.
How long do you expect it to be at the bodyshop?
Posted: Sat Jan 12, 2008 3:53 pm
by Thomas L
Hi Barry
I hope it will finish in about 4-5 weeks, its the same place where the car is getting blasted.
Look at this link, i now its on danish but go through the galleri and check the cars he has done in the past.....
http://www.jyderup-sandblaeseri.dk/Bilg ... lliste.htm
Regards Thomas
Posted: Sun Jan 20, 2008 1:12 am
by red67
thomas's legendary project deserves an 'in-action' shot to show a little of all his effort and work.
doing the below today in scandinavian winter is pure passion.

Posted: Wed Jan 30, 2008 5:24 am
by Thomas L
While waiting for the bodyshop.......................
Now it almost looks like a 911 again...........
Looks like this could be a car again, going to the blaster and bodyshop friday 1st of feburary 2008
Ill keep You updated
Thomas
Posted: Wed Jan 30, 2008 5:36 am
by Thomas L
A new shipment is going to the powder coated....

Off we go
Posted: Fri Feb 01, 2008 9:45 pm
by Thomas L
Posted: Fri Feb 01, 2008 10:14 pm
by Bootsy
Great work, great thread
Posted: Sat Feb 02, 2008 5:18 pm
by Helen

i'm impressed.
loving this thread

Posted: Sun Feb 03, 2008 8:49 am
by ged914cymru
fantastic work! but I take it from the spread on the dining room table that there's no MRS L????
