Workingf late nights!
I dismantled the cyl 3&4 head for overhaul, didn´t look to bad. (The valve stem seal´s had come off though!)I´ve lapped the valves and set correct height on exhaust/intake valves. Will lap the cyl to the head and then I am hopefully ready for reassembly.
I´ve mounted the pass. side door frame with new felt seals (seams like you have to use some backing under the felt seals in some places in order to have a good window fit, anyone familiar with this?
Also installed door handles on both doors but the seals I had bought were inocorrect (68-) I reconditioned the rear, round ones and put new, incorrect ones on the smaller front ones for now.. Also dismantled the door handles and locks, washed and packed them with fresh grease.
I bring to you the God mother of all seals, I spent 1h 45m with this guy tonight! My hands are hurting really, really bad! I used soap, air, everything could think of but it just didn´t want to slide smothly! What am I doing wrong?
Front fenders off for final prep before installation.
Still dreaming of driving it before the end of May.. .
Used one to remove some old shrink tubing. 
