The 'Maverick' Classic Porsche Forum and Classic Porsche Club for Porsche 356, Aircooled Porsche 911, Porsche 912, Porsche 914 & Porsche Replicas. 'We join for the cars but stay for the people'
Is it a relay to asssist with the firing of the starter solonoid? Sometimes the current from the ignition switch isn't enough to get the solonoid to throw across enough to make a good contact, and activate the starter motor. The cure is to get the iginition switch to activate the an additional relay, this in turn activates the starter solonoid (another relay), which activates the starter motor, which activates the engine .
Otherwise I can only assume it is an early prototype of a government road pricing tracking device ....
DDK Member1243 07741 273865. Home of the RY Austin 7 Trophy's and Austin Single Seat Racers
looks like a relay of some sort. Either as a security (?) interruptor to stop the starter kicking in, or perhaps to assist the switch, so that the switch operates the relay, which switches the current to pull in the starter solenoid. It is not quite clear in the picture where the two white wires go, One comes from the big +ve post (from the battery) and the other looks to come from the starter solenoid connection. I figure the perhaps the yellow wire used to go direct onto the starter solenoid connector and goes live when cranking....
Got a 914 circuit diagram ?
Tim
Tim Bennett
RHD Targa 2.2T EFI, Triumph ITB's, EDIS and Megasquirt.
"Old enough to know what's right and young enough not to choose it"
#1153
912uk wrote:is this not something to do with HOT start ..
By shortening the wire length from the +12V post to the solenoid, you'd give the starter best chance to kick in. Yes, I'd say it would assist the hot start.
Tim
Tim Bennett
RHD Targa 2.2T EFI, Triumph ITB's, EDIS and Megasquirt.
"Old enough to know what's right and young enough not to choose it"
#1153
I had a hot start issue with the 912E and that is a type 4 motor with a Porsche stamp... So when I looked into all this why it would not start.. I kept finding things on hot start and this addtional relay would solve the problem..
anyway I droped the engine out once to sort any oil leaks etc and I cleaned up the contacts with emory paper to the starter motor only as it was easy to get to.. and it solved it.. it never did it again.. as far as I am aware Justin who owned it next never had any problems with it either so if you do have this problem clean contacts first.....
Voltage drop relay as Barry said. VW's do suffer a bit with this having the engine and ignition switch so far apart. Every Beetle, Type 2 and even my T25 has one of these, it takes all the load off the switch and makes starting a lot more reliable. There is a standard kit for the fourteen made by Bosch, part number WR1, they call it the Low Voltage Relay.
Looks a bit of an ancient relay on your car.
Steve
1970 Silver 914 - Gone but never forgotten........
#1200
912uk wrote:yep and from memory the 2.0tlr heads are the sort after ones..
I stupidly sold a VW type 4 camper van engine for £60 mind you it was 1999
its only the 2.0L 914 or 912e heads that are sought after, the bus ones are just boggo standard, so you are not 'totally' stupid for selling you bus engine for £60.
Having said that the 2.0L Porsche designed heads are more fragile and prone to cracking around the spark plug to valve seat area. I think the 1.7/1.8 are at a premium these days because you can machine them easier for performance mods.