Can anyone identify these bits from my car please (I am pretty sure that these came off of my car, but I have tinkered with a lot of cars since then so possibly not or not original)?
The cup washer is 30 mm diameter. I have a feeling that it was used on my front wings, perhaps to hold the flange to the side of the scuttle?
The screw is 35 mm long and has an 8 mm hex head. I think it was paired with the cup washer, and fits perfectly, but I cannot be certain.
The switch cable thingy is about 30 cm long. The switch end obviously attached to a panel e.g. dashboard and probably had a knob. The other end is squared off and must have gone into a square hole....
Any help much appreciated....
Can you identify these bits please?
Moderators: hot66, impmad2000, Barry, Viv_Surby, Derek, Mike Usiskin
Can you identify these bits please?
Dean
1973T Targa MFI 334 met blu- under restoration https://www.ddk-online.com/phpBB2/viewt ... 28&t=67060
1980 924 Turbo, blu/grn tartan - restored
1973T Targa MFI 334 met blu- under restoration https://www.ddk-online.com/phpBB2/viewt ... 28&t=67060
1980 924 Turbo, blu/grn tartan - restored
- KS
- Nurse, I think I need some assistance
- Posts: 14957
- Joined: Fri May 07, 2004 3:12 pm
- Location: Cornwall
Re: Can you identify these bits please?
The cable is the trip-meter reset cable located under the dash and pushed into the back of the speedometer.
Re: Can you identify these bits please?
Ahhhhh, was someone else that removed that, which explains why I couldn't remember where it went!
thankyou!!
Dean
1973T Targa MFI 334 met blu- under restoration https://www.ddk-online.com/phpBB2/viewt ... 28&t=67060
1980 924 Turbo, blu/grn tartan - restored
1973T Targa MFI 334 met blu- under restoration https://www.ddk-online.com/phpBB2/viewt ... 28&t=67060
1980 924 Turbo, blu/grn tartan - restored
Re: Can you identify these bits please?
Just came across the cup washer while browsing design911 - it's for the floorboards!
Dean
1973T Targa MFI 334 met blu- under restoration https://www.ddk-online.com/phpBB2/viewt ... 28&t=67060
1980 924 Turbo, blu/grn tartan - restored
1973T Targa MFI 334 met blu- under restoration https://www.ddk-online.com/phpBB2/viewt ... 28&t=67060
1980 924 Turbo, blu/grn tartan - restored
-
- Nurse, I think I need some assistance
- Posts: 16872
- Joined: Wed Nov 12, 2003 10:48 pm
- Location: Worcs/W Mids border
Re: Can you identify these bits please?
.
Here you go - picture of my driver's pedal board showing two of those washers
Here you go - picture of my driver's pedal board showing two of those washers
Andy
“Adding power makes you faster on the straights;
- subtracting weight makes you faster everywhere”
“Adding power makes you faster on the straights;
- subtracting weight makes you faster everywhere”
Re: Can you identify these bits please?
Great stuff, thanks!
Dean
1973T Targa MFI 334 met blu- under restoration https://www.ddk-online.com/phpBB2/viewt ... 28&t=67060
1980 924 Turbo, blu/grn tartan - restored
1973T Targa MFI 334 met blu- under restoration https://www.ddk-online.com/phpBB2/viewt ... 28&t=67060
1980 924 Turbo, blu/grn tartan - restored