DDK - Die Deutschen Klassiker

I'm having another go at sorting this out... and I think I may need a few extra bits to get the lights to sit and clip in place at the top. Do I need to get 2x 'Headlamp to wing seal', 'Headlamp bezel outer screw' and 'Headlamp inner screw'? Any advice would be appreciated...

http://www.design911.co.uk/index.htm?Region=UK

cheers...

I think you will just need two gaskets, plus the main headlamp unit (£69), I suspect the other bits are already attached to the main headlamp unit, and are simply available if they've got lost or whatever.

HTH.

Barry's right - you just need a pair of Bosch H4 headlamps & a pair of the rubber (headlamp-to-body) seals if they're in poor condition (or missing).

Hi Scott I have a pair of chrome H4s, good chrome one just a slight dimple in the bezel that should push out. Yours for £100 + p/p

You may need to fiddle slightly with the wiring as my US spec lamps had different connectors, nothing too difficult though

Cheers guys.

I've already got the light units, but they were given to a garage to fit sometime ago. They couldn't do them, or didn't want to, but there now seems to be a few bits missing. I've only just got round to looking at this myself. I have screws with them, but they require a nut the other side! So maybe I need to buy those bits I mentioned?

I presume my existing rubber seals from unit to wing that are already there will do the job nicely then...

The headlamps 'hook' over the lip at the top of the headlamp bucket & then the screw at the bottom of the chrome rim screws into the small bracket at the bottom of the bucket.

You may need to spend a bit of time ensuring that the hole in the bracket lines up with (& is at the right angle to) the screw (bending the bracket accordingly).