Page 1 of 1
Front scuttle repair
Posted: Mon Nov 25, 2024 10:13 am
by RobFrost
Does anyone know if there's a repair panel available for the channel that holds the rubber seal at the base of the front scuttle? I can see the whole thing is available, but I just have some corrosion in the base of the channel that holds the rubber seal at the top of the bonnet. Obviously I can fashion one but if one's available it'll save me some time. I had a good search but couldn't find one and I don't think it's worth £500 for the whole thing if I'm just using a tenth of it.
https://type911shop.co.uk/epages/de867c ... ucts/17232
Re: Front scuttle repair
Posted: Mon Nov 25, 2024 2:40 pm
by 911hillclimber
The corners are available Rob, Gary71 used a pair a few years ago.
I think his came from Rose Passion, but I'm sure Dansk do them, see below
Rose:
109 Euro each, # P71324/5 (handed parts)
Design911:
£90.62
59101700/1 (LH)
8 (RH)
The Dansk/Design911 items are stated to be off fresh tooling!
Front scuttle repair
Posted: Mon Nov 25, 2024 9:27 pm
by Gary71
I used the restoration design parts for the corners which were a pretty good fit and made a short section for a bit in the middle. This was harder than it looked as it wasn’t straight!
Re: Front scuttle repair
Posted: Thu Nov 28, 2024 3:19 am
by RobFrost
Darn it, my corners are perfect. It's the centre channel that's corroded. I can see a day's work in making one up.
Sent from my SM-S918B using Tapatalk
Re: Front scuttle repair
Posted: Thu Nov 28, 2024 9:08 am
by 911hillclimber
As Gary says, the centre section is a tease, did a few inches of mine a few years ago.
If you don't have holes in the lower front/ rear windscreen areas count yourself lucky....
Re: Front scuttle repair
Posted: Sat Nov 30, 2024 5:19 pm
by Jonnydaz53
Hi Rob i think i have the front scuttle panel you may need , Pm if you still need it .
Thanks
Re: Front scuttle repair
Posted: Tue Dec 03, 2024 10:33 pm
by Cookie
Might be able to help