Page 2 of 2

Re: 1973 911T Seats?

Posted: Thu Nov 03, 2022 2:58 pm
by IanM
I think '73 was the only year that had seats pads made of foam. Pre'-72 pads were made of needle felt which are available from Reutter Karroserie. I've never tried them but their pictures look good.

Re: 1973 911T Seats?

Posted: Thu Nov 03, 2022 8:49 pm
by IanM
According to this vid (time lapse 34:28), Wuppertal are using a reinforced spring box. I wonder where they get them from? :?:

https://www.youtube.com/watch?v=c3uKrV7Dbvc

Re: 1973 911T Seats?

Posted: Sat Nov 05, 2022 5:53 am
by RobFrost
Following

Sent from my SM-G988B using Tapatalk


Re: 1973 911T Seats?

Posted: Thu Nov 17, 2022 1:10 pm
by g3ngs2
I looked long and hard at those Cobra seats as on option. Though in the end went with the Mark W option with corduroy inserts.

The Cobra upper parts were ok but the seat bases seemed too narrow compared to Mark's (not saying I've a fat arse, more in comparison to the originals)



Sent from my SM-G981B using Tapatalk


Re: 1973 911T Seats?

Posted: Thu Nov 17, 2022 8:40 pm
by Nine One One
There were these listed by a member a few days ago for 911 HC??

Re: 1973 911T Seats?

Posted: Thu Nov 17, 2022 10:27 pm
by 911hillclimber
The seats I borrowed from Gary were Waring ones, and were superb. I'm not a huge person, %' 10"/ 11 stone, 33" waist, and the comfort was spot-on.

This will have to wait for a while, all the doom and gloom over the UK is killing off any mojo towards the 911 atm.

Re: 1973 911T Seats?

Posted: Fri Nov 18, 2022 2:19 am
by Nine One One
911hillclimber wrote: Thu Nov 17, 2022 10:27 pm This will have to wait for a while, all the doom and gloom over the UK is killing off any mojo towards the 911 atm.
Well at least your pension is going up by 10.1%

Re: 1973 911T Seats?

Posted: Fri Nov 18, 2022 9:24 am
by 911hillclimber
Yes, quite a surprise last night watching the news.
The advice from our Money Adviser is to not draw down any pension and be careful.
This is not his usual approach..

Re: 1973 911T Seats?

Posted: Tue Dec 13, 2022 2:07 pm
by IanM
IanM wrote: Thu Nov 03, 2022 8:49 pmWuppertal are using a reinforced spring box. I wonder where they get them from? :?:
Apparently, the factory offered this an option, M405 and M406.

https://www.early911sregistry.org/forum ... ost1140599