Page 1 of 1
Installing a 911 oil tank in a 912
Posted: Thu Jul 14, 2022 6:18 pm
by SeanP
Hi
Does anyone have the setting out dimensions and hole sizes for installing an early 911 oil tank in a 912?
I know that the rear inner wing has the indentations already but really want the factory hole sizes so I can install the rubbers etc
Thanks in advance
Sean
Re: Installing a 911 oil tank in a 912
Posted: Fri Jul 15, 2022 9:34 am
by Lightweight_911
.
Have a look at p17 of Chris Jury's '912 outlaw project' thread :
http://www.ddk-online.com/phpBB2/viewto ... &start=240
Chris carried out that job ~ 10 yrs ago & may still have the template details ...
.
Re: Installing a 911 oil tank in a 912
Posted: Fri Jul 15, 2022 11:02 am
by SeanP
Thanks Andy
hats the later tank. I am looking for the sizes of the hole sizes for the earlier tank
Regards
Sean
Re: Installing a 911 oil tank in a 912
Posted: Fri Jul 15, 2022 1:07 pm
by visualfx
Hi Sean
I have 65 in without the engine an tank will that do?
Re: Installing a 911 oil tank in a 912
Posted: Sat Jul 16, 2022 9:09 am
by SeanP
Hi Garry
That would be perfect. If you could make a paper template or even give me the measurements that would be great.
Ill give you a call next week.
Regards
Sean
Re: Installing a 911 oil tank in a 912
Posted: Sat Jul 16, 2022 9:46 am
by visualfx
That's fine Sean, car is leaving us on Weds so let's try an detail before then.