Page 1 of 1
Should I have a hole under the trim?
Posted: Thu Jun 02, 2022 5:07 pm
by neilbardsley
On the metal trim either side of the rear window should there be a hole at the bottom to fix it? On the side which has come off I have a hole on the side which is still in place I don't.
Sent from my M2004J19C using Tapatalk
Re: Should I have a hole under the trim?
Posted: Thu Jun 02, 2022 8:05 pm
by Ian Gunney
yes Neil - there is a bracket (which slides into the sail panel trim) with a thread that goes through the hole.
Ian
Re: Should I have a hole under the trim?
Posted: Fri Jun 03, 2022 4:37 pm
by neilbardsley
Thank you
Sent from my M2004J19C using Tapatalk
Re: Should I have a hole under the trim?
Posted: Sun Jun 05, 2022 10:59 am
by neilbardsley
Is this what they look like? I can only find them in the States so I might have to make some
Sent from my M2004J19C using Tapatalk
Re: Should I have a hole under the trim?
Posted: Sun Jun 05, 2022 12:59 pm
by neilbardsley
I'm struggling to see how the bracket)clip fits to the trim
Sent from my M2004J19C using Tapatalk
Re: Should I have a hole under the trim?
Posted: Sun Jun 05, 2022 6:00 pm
by Nine One One
I would imagine it actually slides into the groves either side of the trim, where you thumb is, then you bolt it up securely inside the engine bay with a nut that attaches to the thread on the clip.
Re: Should I have a hole under the trim?
Posted: Sun Jun 05, 2022 8:22 pm
by Ian Gunney
I may have one (or two) somewhere Neil - will have a dig.
Ian
Re: Should I have a hole under the trim?
Posted: Sun Jun 05, 2022 9:44 pm
by neilbardsley
Thank you Ian.
I was confused about the hole in the back of my trim. I'm guessing that has been added
Sent from my M2004J19C using Tapatalk
Re: Should I have a hole under the trim?
Posted: Wed Jun 29, 2022 6:03 pm
by chief
Hopefully these might make it clearer....
Re: Should I have a hole under the trim?
Posted: Thu Jun 30, 2022 8:44 pm
by neilbardsley
Thank you
Sent from my M2004J19C using Tapatalk