Page 1 of 1
912 Fan Pulley
Posted: Fri Oct 22, 2021 6:30 pm
by adrianscott
Hello
Cannot get back pulley which goes onto the dynamo spindle square on. Wobbles about with shims needed to bring pulley back away from dynamo case. Am I missing something?
Thank you
Re: 912 Fan Pulley
Posted: Fri Oct 22, 2021 7:06 pm
by Timo
Adrian, in your second pic it looks close at the top and gappy at the bottom, is it just a case of it not tightening up squarely? I tend to tighten mine without the pulley locked initially which allows the pulley wheel to rotate a little as you go which allows it to go on squarely, I then lock the pulley and torque up the last bit.
Re: 912 Fan Pulley
Posted: Fri Oct 22, 2021 9:47 pm
by wildtexas
Also your belt is riding low. How many shims do you have and where are they?
Can you tell.us the dimensions of the belt?
Re: 912 Fan Pulley
Posted: Sat Oct 23, 2021 7:58 am
by neilbardsley
I think I might have 1 shim between the half and generator
Sent from my M2004J19C using Tapatalk
Re: 912 Fan Pulley
Posted: Mon Nov 01, 2021 7:25 pm
by adrianscott
Thank you all. Parts are worn too.