Resto thread for 119100008 69t

leedurrant73 · Post by **leedurrant73** » Wed Oct 13, 2021 9:22 pm

I have got some verniers in the garage but there small. My lining is still in at the moment.
Little but frightened to remove the front and rear windows haha

leedurrant73 · Post by **leedurrant73** » Thu Oct 14, 2021 4:14 pm

Seem to be getting an extensive list of replacement parts ready for the restoration now. The car some seem to have much rot yet. So crossing the fingers.

Sent from my iPhone using Tapatalk

Gary71 · Post by **Gary71** » Thu Oct 14, 2021 4:54 pm

Hope that lack of rot carries on.

Take that brave pill and get the screens out, see what you find on the corners. Unless they’ve been glued in it’s normally only one good shove and they are out.

leedurrant73 · Post by **leedurrant73** » Thu Oct 14, 2021 5:33 pm

That’s funny. I remember a bit of metal work passenger side of front window that needs work.

Will look on you tube for windows removal

Thanks

Gary71 · Post by **Gary71** » Thu Oct 14, 2021 6:54 pm

Gentle (or violently if not reusing!) the aluminium trims then push the top corner of the screen from the inside with the flat of your hand and you should find it start to move. Then do the other corner and work back and forth until it releases

leedurrant73 · Post by **leedurrant73** » Thu Oct 14, 2021 10:39 pm

Is it worth folding back the rubber and spraying some wd40 inside the seal ?

911hillclimber · Post by **911hillclimber** » Fri Oct 15, 2021 8:23 am

^^^ That's what I did 2 years back when I re-painted mine. Both eased out very easily, re-used everything.

30+ years ago when I restored mine there was rot everywhere, except the screen corners.
30 years on and really summer use only, there was significant perforation of the lower corners, tedious repairs followed.
Rears worse than the front, drains installed on all 4.

leedurrant73 · Post by **leedurrant73** » Fri Oct 15, 2021 10:16 am

Fantastic I’m gradually learning.

Having a go when I can…. Thanks

leedurrant73 · Post by **leedurrant73** » Fri Oct 15, 2021 4:25 pm

No rot in the corners of the window. Really pleased. I got it out in one piece

Sent from my iPhone using Tapatalk

Gary71 · Post by **Gary71** » Fri Oct 15, 2021 6:32 pm

Great result! Parcel shelf back edges ok?

leedurrant73 · Post by **leedurrant73** » Fri Oct 15, 2021 6:52 pm

Hello Gary,

I was advised to replace the parcel shelf because it has speaker holes cut. I’ve purchased a replacement.
Not rot from what I can see. Will paint strip the area around the window.

Thanks for your help mate !

Gary71 · Post by **Gary71** » Fri Oct 15, 2021 6:54 pm

If it not rotted just repair the holes.
It’s quite intrusive getting it out and making sure it goes back in the right place so the engine lid still shuts.

RobFrost · Post by **RobFrost** » Sat Oct 16, 2021 8:22 am

leedurrant73 wrote:Got back to the resto today for a little while.

Could someone tell me if the roof section is made out of different metal to the other panels?
The paint removal was so much easier and the metal seems much shinier than the rear wings and doors?

One paint strip on this panel and it came off?

Is it magnetic?

Sent from my SM-G988B using Tapatalk

leedurrant73 · Post by **leedurrant73** » Sat Oct 16, 2021 10:48 am

Gary71 wrote:If it not rotted just repair the holes.
It’s quite intrusive getting it out and making sure it goes back in the right place so the engine lid still shuts.

That’s what I thought originally and will ask. Do you think it would save money.
Smaller job to patch rather than fit a whole new shelf?

Gary71 · Post by **Gary71** » Sat Oct 16, 2021 10:53 am

Absolutely easier to repair.
However if there is the slightest hint of crusty right in those back corners or in the closed section that runs across the car then whip it out.

DDK - Die Deutschen Klassiker