Resto thread for 119100008 69t

[leedurrant73]

Ok thanks guys

[leedurrant73]

Does anyone have a good picture of the small bracket attached to the front partition panel which holds the water sprayer bottle?

Thanks


Sent from my iPhone using Tapatalk

[Lightweight_911]

.
Hopefully someone will post a better photo but there are a couple of (poor quality) pictures in this thread:

https://forums.pelicanparts.com/porsche ... -73-a.html

.

[leedurrant73]

Hey thanks Andy much appreciated

[leedurrant73]

Last question guys.

I have some holes on the underside of the Floor in each corner?

Surely they can be drainage as there are on holes on the inside of the floor. Any ideas?






Sent from my iPhone using Tapatalk

[Gary71]

Previous wax injection?

[leedurrant73]

That sounds good news mate

[leedurrant73]

Hello,

Can anyone tell me if minor scratches on the anodised window frames can be polished out?

Any idea what product if any?

I’m sure I read leave alone when it comes to restoring the frames if you can get away with it?

Any ideas ?
Thanks


Sent from my iPhone using Tapatalk

[911hillclimber]

You need Gary71!

[Gary71]

Don’t ask me, I just ripped all the anodising off!

I had no success at all getting scratches out of the anodising, tried everything so ultimately just sanded them back with multiple grades and then polished them. After a year and all forms of weather they seem to be holding up with zero maintenance.

All I’d advise is if you start sanding them back you have to finish, and it’s a whole load of work including the rear 1/4 windows.

[leedurrant73]

Ok thanks mate. I think I’m going to leave well alone
Appreciate the advice

[911hillclimber]

I left mine well alone for the last 35 years, too much hard work!
They are all original 1973 with a lot of scars, but be Yong 3 feet away you can't see anything bad.
, bit like my whole car really!

[RobFrost]

Does anyone have a good picture of the small bracket attached to the front partition panel which holds the water sprayer bottle?

Thanks

https://www.design911.com/p/porsche-911 ... 150147820/

It's thicker gauge than the bodywork, say 2mm.

[leedurrant73]

Hello all.

Sorry for so many questions. Thought I’d ask a few relating to what I can do while the car is having metal work.

The indicator housing rubbers, do they have to be glued in position prior to the lenses going back on?

If so what glue is normally used ?

Thanks Lee


Sent from my iPhone using Tapatalk

[RobFrost]

If you mean the rubber between the unit and the lenses, I'm pretty sure mine (1970) had a slot cut in the foam which pressed onto the edge, and no glue apparent.

Sent from my SM-G988B using Tapatalk