Page 1 of 4
1969 912 LWB
Posted: Thu Dec 12, 2019 11:10 am
by Hebster52
Re: 1969 912 LWB
Posted: Thu Dec 12, 2019 11:11 am
by Hebster52
Re: 1969 912 LWB
Posted: Thu Dec 12, 2019 11:14 am
by Hebster52
Re: 1969 912 LWB
Posted: Thu Dec 12, 2019 11:37 am
by KS
Looking good - and looking very cold!
Re: 1969 912 LWB
Posted: Thu Dec 12, 2019 11:43 am
by Bootsy
Looking forward to seeing it develop
Re: 1969 912 LWB
Posted: Thu Dec 12, 2019 1:48 pm
by Lightweight_911
.
After following your 356 Coupe replica build & been mightily impressed with the skills & effort you put into that, I'm sure this is going to be an unmissable thread ...
.
Re: 1969 912 LWB
Posted: Thu Dec 12, 2019 4:55 pm
by rhd racer
Great work. Intrigued to know how you worked those corners into shape as I can’t see any spot weld marks from a puller. Was it purely heat and worked from behind?
Looking forward to the thread
Re: 1969 912 LWB
Posted: Thu Dec 12, 2019 8:01 pm
by Gary71
Ah! Should have realised you’d already be on DDK when I posted on Facebook. Welcome again with a new car
Re: 1969 912 LWB
Posted: Thu Dec 12, 2019 8:44 pm
by hot66
Makes sense now .... there was me directing to you Ddk too
Re: 1969 912 LWB
Posted: Mon Dec 16, 2019 9:35 am
by Hebster52
Haha, yes. Been lurking into the 911/12 world for a while already besides the former 356 replica project.
And thanks for the help on FB,
Re: 1969 912 LWB
Posted: Mon Dec 16, 2019 11:05 am
by neilbardsley
Subscribed!!
Sent from my Redmi 7 using Tapatalk
Re: 1969 912 LWB
Posted: Tue Dec 17, 2019 5:58 am
by Hebster52
1969 912 LWB
Posted: Tue Dec 17, 2019 6:53 am
by Gary71
Looks good.
I’ve brightened up one of the photos I posted on Facebook so you can see the layers better on a new OE quarter.
The bit that goes to the rear crossmember (that you’ve made) is spot welded to the outer quarter down the inside edge.
To be honest though by the time it’s all leaded and has the rear panel/overiders fitted you’ll never see it so making it in one piece is probably easier!
Re: 1969 912 LWB
Posted: Tue Dec 17, 2019 7:17 am
by Hebster52
Thanks. I planned on making it as in your picture.
Re: 1969 912 LWB
Posted: Fri Dec 20, 2019 9:30 am
by Hebster52
Rolled it out a few days ago to cut out the 912 enginemounts. Decided to test the newly arrived RS rearbumper At the same time, and test the mockup cardboard flare.. :D