What did you do in/on/for your Porsche today?

[Gary71]

Went for a little drive, used opposite lock, found a safe parking spot

[sladey]

Was that to calm yourself down after the dab of oppo?

[Dean.s]

I finally got around to repairing the push rod tube seals and fitting the retaining spring. will be doing the other side next weekend.

Hopefully i can then go for a trouble free drive again.

It's had its butt in the air since july 22!!!

[sladey]

After months and months working on my garage I’m back in my happy place working on the car.

Decided to refresh the front suspension.

Current battling the cotter pin and deciding whether to make a special tool

[KS]

Cool reg on the Cayman...

[hot66]

What’s up with the pin ? Seized ?

[BILLY BEAN]

After months and months working on my garage I’m back in my happy place working on the car.

Decided to refresh the front suspension.

Current battling the cotter pin and deciding whether to make a special tool

Thought you had given up working on your car. Glad to see you are back in action.

[Sam]

After months and months working on my garage I’m back in my happy place working on the car.

Lovely. Indulge yourself.

[RobFrost]

I went to the Midlands Airport cooled swap meet this morning, only having heard about it last night. I was glad I turned up early. The queues were long already and the room heaving. By the time I left it was one in, one out.



I picked up a few bits for the 911T. No idea if that air box is right. Or the bumper, or the windscreen.



Sent from my SM-G988B using Tapatalk

[neilbardsley]

Here are the LED rear lights in the 914. The US-spec lights also have smaller bulbs in the side, so it's quite a light show, but better yet the yellow LED indicator bulbs are bright enough to show yellow/orange through the all-red US lenses...

Do I need 2 bulbs or 4 for the rear of my 914?

Sent from my M2004J19C using Tapatalk

[KS]

Each side needs one turn signal, one brake/tail, one reversing, one side marker (if US spec)...

[Bootsy]

I’ll admit Porsche shenanigans have been low on the list of late. No real reason just lots of life stuff getting in the way! And apologies for lack of air cooled stuff but at least….

…. got the little Boxster back on the road this week. Two new radiators (one was rotted so replaced both whilst the bumper was off) and a few other bits including a new battery: . Only to discover the stereo’s amp had fried itself so a replacement period looking Bluetooth Blaupunkt is on route and going to use it a little more.

Took it out for a country run this evening and it’s about to clock over to 80k




Sent from my iPhone using Tapatalk

[g3ngs2]

After months and months working on my garage I’m back in my happy place working on the car.

Decided to refresh the front suspension.

Current battling the cotter pin and deciding whether to make a special tool

Your garage is just stunning.

Sent from my SM-G981B using Tapatalk

[sladey]

Thanks for the kind comments

What’s up with the pin ? Seized ?

Yes it was seized but being left overnight with heat and wd40 and the next day a BFH freed it.

Had a few similar challenges but one side is all off now.

Planning on just tidying it all up - was lots of surface rust

[Ashley James]

A friend has sold his Macan and bought a Bentley GTC, the V8 one so it’s only 500bhp, felt fast enough to me. Not a great looker but impressive nonetheless and seems to have the same door hinges as my 981S.

However this meant he decided he couldn’t keep his Porsche design, in car Espresso machine and that I should have it. Obviously a must have, although as far as I can see the only Porsche design bit is the label on the generic Chinese container for the coffee pods.



Www.handpresso.Com