DDK - Die Deutschen Klassiker

Has anyone got US style red lense rear lights & who do u use indecators?

Hi Oliver

I dont think the US speck red lenses will get you through the MOT, unless your donor vehicle is pre 1962 (ish). Not sure about SVA/IVA either.

I know when I fitted my lights I used euro lenses, but, had to change the bulb holders round so that the stop/tail light was in the red section and the indicator was in the amber section. It was a real pain in the a£$e.

In hindsight I wish Id have gon for the older style round rear lights !!!!!

Hi steve Ive have used LED bulbs ,red one for the lights & brake & an amber one on the indecators & with them being so bright it showes through as amber. hope it will pass

Hi Oliver

where did you get the LED bulbs ??? sounds like a good idea !

How are you getting on with the build ?

regards

Steve

Its coming along slowley Ive managed to get all the parts to fit after a lot of work ,just finishing the rear engine boot after many calls to Mr Tanner I told him to send it in two parts so I could get it to fit the body properly, Ive also lined inside it in ally so u dont so the glass . Like you said you become an expert in fibre glassing .The( sill) issue got solved in the end by clamping stainless angle behind them & glassing them in & griding them to the door lines .The bulbs were from ebay but Halford sell them aswell .Im also going to fit a third brake light in the engine grill & the light is thin & clear & not red until lit.Thinking of puting in tiny clear LED side indecators hidden in the trim?Did u enjoy the snow?

My new 'euro spec lights' have the stop and tail behind the indicator lens and indicator behind the red lens. I can't see how i am going to swap them over as the housings seem to be part of the rear reflector.
I bought then from auto atlanta. As soon as i opened the box and saw made in taiwan on the side i knew i had a made a mistake. Could try a red lens and orange bulb i suppose...

Housings are fairly easy to swap over, just need to carefully bend back the edges of the bulbholders and detach....

Takes around 10/15 mins each holder....

Hmm. Think i must have something different to you. Also the indicator and stop/tail bulb holders are different sizes. Not exactly euro-spec lights in their current state, i am awaiting their response.

My old one, ( I used it to practice on )



see the bulbholder....had crimped edge, (bent back in the pic).

And in the reflector you can just see where the bulbholder sat and how it was crimped...

Put the holder in the correct place and bend the edge back over....I then smeared with silicon on the back to seal. My bulbholders were the same size.

i have an extra set that i took off my build when i converted to bee hives.

plastic - all red from a replica (not oem). shoot me an offer - these are just sitting on y shelf in the garage gathering dust.