Page 1 of 1
vw clutch on 356 flywheel
Posted: Fri Jun 27, 2008 8:38 am
by Ren
Hi all, can anyone tell me the depth the flywheeel must be to except a 200mm VW clutch. I wish to get my 180mm flywheel machined out.
Dave Ren
200 mm VW clutch
Posted: Sun Jun 29, 2008 7:14 pm
by Nigel Cousins
Hi Dave
I had my flywheel machined recently to take a 200 mm clutch I also had the out side profile machined to match a super 90 which saves a bit of weight but not too much to loose torque.Claren tooling in Boscombe did the work for £70.
I will dig it out as I have not put this engine together yet and post the dimensions you need.
Cheers Nigel
VW clutch 356 flywheel
Posted: Mon Jun 30, 2008 12:41 pm
by Ren
Nigel thanks that would be great help.
vw clutch on 356 flywheel
Posted: Mon Jul 07, 2008 7:13 pm
by Nigel Cousins
Hi Dave
The dimensions you need are:
The outer ring depth for the cover plate = 4.5mm
From the bottom of the cover plate face above( i.e 4.5 mm down) to clutch running face=21.3mm
Hope this is OK let me know if you need any more info.
Best regards Nige
vw clutch on 356 flywheel
Posted: Wed Jul 09, 2008 8:39 am
by Ren
Nige, My kennedy pressure plate has a round piece in the centre on the finger spring bits that my old Sache pressure plate did not have. Do I have this removed? Also I have a C gear box, which throw bearing is best?
I have a measurement of 21.5 from Duane Spencer book?
Much thanks.
DRen
vw clutch on 356 flywheel
Posted: Wed Jul 09, 2008 12:43 pm
by Ren
Right I have some more sizes:
outer ring to first surface 4mm
pressure plate surface to clutch surface 21mm
with 203mm diameter hole.