![Image](http://i124.photobucket.com/albums/p33/Highfield_Photos/Misc/STFrontRight.jpg)
I have stripped them apart and given them a good scrub up :-
![Image](http://i124.photobucket.com/albums/p33/Highfield_Photos/Cibie%20Pallas%20Lamps/DSCF0507.jpg)
![Image](http://i124.photobucket.com/albums/p33/Highfield_Photos/Cibie%20Pallas%20Lamps/DSCF0506.jpg)
I am going to get the trim rings re-chromed inside and out, as well as yellow zinc coating the base mount inside the pod, and the ring that the lense attaches to.
The brackets will be powder coated satin black - is this correct ?
Should I have the pods blasted (a little rust inside only) and then painted or powder coated in ivory white. Can I consider painting from a rattle can, or is the finish really not good (not done it for years).
The bulbs are H1 55W, and one looks dubious - any idea where I can get these from.
I also need one of the multi pronged brackets that holds the yellow reflector to the bulb holder - any idea where from ?
Finally, the lenses are great, but the reflector has a little pitting around the edge on the outside (the bronze outer section) - shall I just grey rust paint this rim ?
The big job is fitting them, as I need a separate relay and a suitable dash mounted switch - and I am no way an electrician, so will need lots of advice, but this is something I can work through and enjoy when they are mounted.
Ian