Gearbox ID

Porsche 356 Virtual home

Moderators: 58A - 71E, Helen

58A - 71E
Put a fork in me, I'm done!
Posts: 1842
Joined: Tue Nov 28, 2006 1:49 pm
Location: Yorkshire

Gearbox ID

Post by 58A - 71E »

Got around to blasting the case with the degreaser at the weekend to try and ID the gearbox, drain the oil etc but now I'm not sure what I actually have!
Brief medical history:
The car was imported from S.A. in 1988 and I have an invoice from Barry Curtis dated december '88 for a full engine rebuild when the original crankcase, crankshaft, bearings, cylinders, pistons, valve guides, camshaft, distributor were all changed plus a load of other bits including gearbox mounts(cost £2297 back then!)
Then I have another invoice dated Feb 1994 from Roger Bray's where the original gearbox was exchanged for a secondhand unit (£1200)
Therefore non matching numbers car - but that doesnt bother me as the engine ID is period from 1958 as it should be, but would like to work out what the gearbox is :roll:
I know from its birth certificate it should have gearbox number 18760 in it but instead I have number 10575 (stamped along the bottom and near the starter motor opening on the bell housing). Trouble is I cant find any reference to this gearbox number in any of the books/references I have. It has dual mounts and the mushroom type breather
I've attached a couple of pics which aren't very clear, but the other numbers are:
Image
2102 and 26 next to the VW stamp left of the transaxle

Image
On this side looks like 113 301 102 next to the VW stamp right and below the mushroom, but it has really faded/corroded
On both sides of the case (under where the hoop attaches) is the number 870 other than that there are no other markings I can see :?

So, is this likely to be a 519 rather than the 644 it would have had - and if so how identified? - or is it a VW 'box? If so any ideas what/when from? or is it possible to mate the hockey stick/nose from a porsche unit to a VW???????

Either way I'm going to have to operate as I found these in the drain plug :shock: and I was starting to have those 'will it wont it' moments when shifting before taking it off the road
Image

Cheers

James
Last edited by 58A - 71E on Wed May 30, 2007 4:08 pm, edited 1 time in total.
James

'58 356A 1600n
'71 911E 2,2


#0335
Nic B-C
DDK above all
Posts: 153
Joined: Sat Jan 14, 2006 1:32 pm

Post by Nic B-C »

Image

Hope this helps,just taken one apart in a B recently check out pics in resto
http://www.stoddard.com/shop/images/pg18transID.JPG
Newest VW/Porsche Club in NE specialising in technical data
www.durhamdubbers.co.uk
Nic B-C
DDK above all
Posts: 153
Joined: Sat Jan 14, 2006 1:32 pm

Post by Nic B-C »

Think that makes yours a 519!
Newest VW/Porsche Club in NE specialising in technical data
www.durhamdubbers.co.uk
Nic B-C
DDK above all
Posts: 153
Joined: Sat Jan 14, 2006 1:32 pm

Post by Nic B-C »

They do clean up
Image
Image

Only used engine degreaser
Newest VW/Porsche Club in NE specialising in technical data
www.durhamdubbers.co.uk
Nic B-C
DDK above all
Posts: 153
Joined: Sat Jan 14, 2006 1:32 pm

Post by Nic B-C »

Image

The one Ive just done is a 741 from this code
Newest VW/Porsche Club in NE specialising in technical data
www.durhamdubbers.co.uk
cubist
The Fenland Feltcher
Posts: 4044
Joined: Wed Dec 03, 2003 12:48 pm

Post by cubist »

I'm assuming you didn't have synchro on 1st? Looks to me like a split case 519 from a pre '56 A... could well be filled with beetle cogs and widgets as well. I've seen a couple of beetle-based splitcase boxes in early 356s in the past that didn't shift very well either :wink:
C U B I S T - 1 1 1 5

'83 Triumph Acclaim - 3sp Auto (cat D)
Singer 3232 - Titanium bobbin, Autothread
'67 Gresham Flyer - Puncture, rear
Sherbet Lemons - 4oz, loose
Motorola - PG 2000, locked
58A - 71E
Put a fork in me, I'm done!
Posts: 1842
Joined: Tue Nov 28, 2006 1:49 pm
Location: Yorkshire

Post by 58A - 71E »

Thanks Nic - I saw this transmission diagram in the Stoddard catalogue but the number on mine is 10575 i.e. 5 digits. I assumed they would go from 1099 to 11001 so I couldnt work out where 10575 fitted into this nuumbering scheme, hence wondering if it was a VW unit (tell me I'm missing something here!)
I have seen an article in the 356 technical and restoration guide that describes the numbers in detail, but this case doesn't seem to have all the markings that it should
Also not sure what dates refer to Magnesium and which to Aluminium cases, as the nose from mine is definitely different to the rest of the case(suspect Al nose) hence my suspicion as to whether it was a butchered version of two - anyone know if the earlier boxes had this construction? It definitely makes cleaning it harder with degreaser :x
I wondered if the 26 referred to Feb 56 but not sure about the 2102 unless this is trying to describe the gear ratios :?

Cubist - 1st was always interesting :wink: but I have crash first and reverse in the MGA and the 356 always seemed a lot easier than that, so not sure if it was supposed to be crash or not.
If the case is a 519 I'll rebuild it as such but the number wouldnt suggest this if I read the stoddard catalogue diagram correctly - if - :oops:
James

'58 356A 1600n
'71 911E 2,2


#0335
Nic B-C
DDK above all
Posts: 153
Joined: Sat Jan 14, 2006 1:32 pm

Post by Nic B-C »

I think there must be a mistake on the labelling on that diagram with the first twos numbers and they have missed a 1 off the front of it which would tie in with the next series of boxes
Newest VW/Porsche Club in NE specialising in technical data
www.durhamdubbers.co.uk
Jez 356
Married to the DDK
Posts: 219
Joined: Wed Aug 25, 2004 9:45 am
Location: Salisbury, Wilts

Why not upgrade ?

Post by Jez 356 »

Would it not be better to upgrade to a later box ?

I have a 741 in my A and it runs very well

As you do not have the matching numbers gearbox it might be a good idea ?

Also a Pre - A box might be worth more to a Pre - A owner ???
Jez
1956 356A
www.356registry.org/Members/Mardle/index.html to see my car but the pics needs updating.
High mileage workhorse 02 Chrysler PT Cruiser CRD
58A - 71E
Put a fork in me, I'm done!
Posts: 1842
Joined: Tue Nov 28, 2006 1:49 pm
Location: Yorkshire

Post by 58A - 71E »

Nic - thanks for your help - I think you might be right about that diagram, which is what confused me in the beginning, but I think its missing a 9 not a 1 i.e. 10999 then start at 11001, which would mean mine is one of the last 519 dual mounts probably from very late 1955 or early 1956 - which I am more inclined to believe given the stamp 26 - Feb '56?. Having just re-read the Technical and Restoration Guide (page 218) this time carefully, they have data up to 10538, which is a dual mount 519 with magnesium case and aluminium nose (like mine!) and says they changed sometime in 1956 to the aluminium case 644 (but the internals are 98% 519) which is what it would have had originally.
Jez - a later box would be good, but I reckon I'll rebuild it unless someone has number 18760 in a 1956 T1 and wants to do a swap!
Cheers

James
James

'58 356A 1600n
'71 911E 2,2


#0335
Nic B-C
DDK above all
Posts: 153
Joined: Sat Jan 14, 2006 1:32 pm

Post by Nic B-C »

Silly me yeah 9 would be right leaving out a box on the numbering between the two runs.

Good luck with your quest
Newest VW/Porsche Club in NE specialising in technical data
www.durhamdubbers.co.uk
cubist
The Fenland Feltcher
Posts: 4044
Joined: Wed Dec 03, 2003 12:48 pm

Post by cubist »

I've just swapped my 644 for a 741 - or rather we took the innards from the 741 and slipped them into the 644 casing. Works a treat and shifts smoother than it ever has done, well worth the greasy messing about. As Jez says - sell the 519 to 912uk or another 'vintage' owner :wink:
C U B I S T - 1 1 1 5

'83 Triumph Acclaim - 3sp Auto (cat D)
Singer 3232 - Titanium bobbin, Autothread
'67 Gresham Flyer - Puncture, rear
Sherbet Lemons - 4oz, loose
Motorola - PG 2000, locked
58A - 71E
Put a fork in me, I'm done!
Posts: 1842
Joined: Tue Nov 28, 2006 1:49 pm
Location: Yorkshire

Post by 58A - 71E »

Just thought I'd share what I found when I opened the gearbox up at the weekend -
Image
the flash doesnt help but after removing the intermediate plate - cast into the ends of the split case are the numbers 5 9 15 5 7 35 so I reckon it is definitely a type 591 gearbox
Also
Image
shows a date stamp of 5-1-56 so my guess wasnt too far off!
Just that the external markings were not so obvious
Anyway, found out what the problem was with the 'will it wont it' shifting - :shock:
Image
Think it needs a dentist :lol: luckily thats the only sign of any damage
James

'58 356A 1600n
'71 911E 2,2


#0335
Nic B-C
DDK above all
Posts: 153
Joined: Sat Jan 14, 2006 1:32 pm

Post by Nic B-C »

Should be a relatively easy fix then :)
Newest VW/Porsche Club in NE specialising in technical data
www.durhamdubbers.co.uk
cubist
The Fenland Feltcher
Posts: 4044
Joined: Wed Dec 03, 2003 12:48 pm

Post by cubist »

I had a few of those! Which one is it as i've got plenty of spares that aren't munched :wink:
C U B I S T - 1 1 1 5

'83 Triumph Acclaim - 3sp Auto (cat D)
Singer 3232 - Titanium bobbin, Autothread
'67 Gresham Flyer - Puncture, rear
Sherbet Lemons - 4oz, loose
Motorola - PG 2000, locked
Post Reply