356 floor pan pictures required

rupert the bay · Post by **rupert the bay** » Thu Jan 11, 2007 12:26 pm

anyone got any decent pics of 59 356 floorpans.....either in car, under car or just pans themselves

much appreciated for anything you find
the more.....the better

cheers folks

Rustbucket · Post by **Rustbucket** » Thu Jan 11, 2007 1:40 pm

not sure if its a '59 one?

heres some off restoration designs site:

http://www.restoration-design.com/index.html

Dan
PS I got mine from here- they are good

cubist · Post by **cubist** » Thu Jan 11, 2007 2:55 pm

Ditto that Rusty

rupert the bay · Post by **rupert the bay** » Thu Jan 11, 2007 3:36 pm

cheers fella

think i might have a go at re-producing some

should be a laugh

912uk · Post by **912uk** » Thu Jan 11, 2007 3:47 pm

That p19 pic you can see the lower bowls I have cut out of the sheet I have... so the rest is spare. I was going to cut it up and use the metal but would consider selling it if this helps you out..

Rustbucket · Post by **Rustbucket** » Thu Jan 11, 2007 5:30 pm

I think the only difference is the pressing at the toe panel end, something to do with the circle being different.

rupert the bay · Post by **rupert the bay** » Fri Jan 12, 2007 2:39 pm

912uk wrote:That p19 pic you can see the lower bowls I have cut out of the sheet I have... so the rest is spare. I was going to cut it up and use the metal but would consider selling it if this helps you out..

how much you looking for ....

i`m very poor and have to rebuild my 356 using only sheet steel a hammer , chisel and wood, please bare this in mind

Rustbucket · Post by **Rustbucket** » Mon Jan 22, 2007 1:32 pm

heres mine.............

rupert the bay · Post by **rupert the bay** » Mon Jan 22, 2007 4:27 pm

you got any more pics rust bucket, of the rear too ?

Rustbucket · Post by **Rustbucket** » Mon Jan 22, 2007 6:11 pm

I have some pics online at:

www.themodelmaker.co.uk

under ' custom vehicles', scroll down to the porsche. I have more/ better ones somewhere, poss online, so I will dig em out..