FS:911/914 parts - DO NOT REPLY TO THIS THREAD

early2.2S · Post by **early2.2S** » Sat Oct 10, 2009 2:29 pm

Re the 911 airbox - if it is still for sale can you tell me if its plastic or metal.
Thanks
Stuart

amallagh · Post by **amallagh** » Sat Oct 10, 2009 3:29 pm

Hi Stuart,
as I mentioned in my last message the airbox has now sold. Just waiting on the buyer to collect. It is a metal one. Had been on there some time. I keep adding and removing parts from my original post as things come along spare from my projects.
Andrew

judgespeed · Post by **judgespeed** » Sat Oct 10, 2009 7:39 pm

hi, is the front scuttle panel still for sale? I will take it if so

amallagh · Post by **amallagh** » Sat Oct 10, 2009 8:53 pm

judgespeed wrote:hi, is the front scuttle panel still for sale? I will take it if so

It's yours. I'll PM you details

The Minotaur · Post by **The Minotaur** » Mon Oct 12, 2009 10:10 pm

Hi, please could I take the oil catch tank if it has not already been sold. PM sent) Thanks. Tim

amallagh · Post by **amallagh** » Mon Oct 12, 2009 10:22 pm

OK Tim,
the catch tank is yours. I'll PM you details
Thanks
Andrew

rhd racer · Post by **rhd racer** » Wed Oct 14, 2009 9:05 am

Andrew

I'll take a 914/6 fr engine bay seal, and two side seals please. Have sent you a pm.

Engine coming out at the weekend - time for it to be sealed as Ferdinand intended, rather than surrounded by all that fresh air!!

Cheers
Wayne

amallagh · Post by **amallagh** » Wed Oct 14, 2009 9:57 am

Hi Wayne,
good to hear the car is handling better with the new suspension set up.
Sods law, pillay2k (Fab) has just asked me for the same seals and I'm just waiting for payment. Have to assume they are sold now unless I hear from him otherwise. I do have some more seal but not quite a full set. I'll PM you details.
Regards
Andrew

judgespeed · Post by **judgespeed** » Sun Oct 18, 2009 7:57 pm

Hi, recieved scuttle panel all good and well described thankyou, been looking for one of these for some time, happy motoring, kind regards Brett

amallagh · Post by **amallagh** » Sun Oct 18, 2009 10:16 pm

Thankyou Brett.

Original parts list updated to remove recently sold parts:-
- Oil catch tank
- Scuttle panel
- 911 air box
- 914 seals

Parts added
- early 911 Hella 128 fog light replacement

More parts to come shortly from 1966 SWB 911
- front and rear torsion bars
- 13mm ARB
- Mastercylinder & reservoir
- Koni Classic damper set (nearly new)
- SWB tie rods
- 410mm early 911 steering wheel
- 380mm (914 or RS) leather wheel covering kit

Winston Teague · Post by **Winston Teague** » Mon Nov 02, 2009 10:14 am

Hi, do you still have the 911/930 valve adjusting screw x2? If so i'll have them and do you have any more?

W

Winston Teague · Post by **Winston Teague** » Wed Nov 04, 2009 10:31 pm

What a service!!!!! I only found out i needed the valve adjusters on Monday morning. In my hand Wednesday. Thanks very much. Winston

amallagh · Post by **amallagh** » Thu Nov 05, 2009 12:52 am

My pleasure Winston.

I anyone is after anything off here then don't worry if you don't hear from me for a couple of weeks as I'm off on Casablanca Challenge rally for the next couple of week in the 914/6. Can't wait.

Tay · Post by **Tay** » Fri Nov 06, 2009 5:19 pm

Andrew
Thanks for the prompt despatch of the CV joint & fittings. Great service,
highly recommended!
Best regards
Tay

amallagh · Post by **amallagh** » Tue Nov 17, 2009 5:56 pm

Thankyou Tay.
Back on line again, 914/6 is a bit the worse for wear but what a rally !!
http://www.ddk-online.com/phpBB2/viewtopic.php?t=27668

DDK - Die Deutschen Klassiker

FS:911/914 parts - DO NOT REPLY TO THIS THREAD

front scuttle panel

Re: front scuttle panel

oil catch tank

scuttle panel 911

CV Joint