DDK - Die Deutschen Klassiker

So is Ben selling these repro dizzied Darren

markm wrote:So is Ben selling these repro dizzied Darren

For sure, he'll soon be adding these to the other parts for sale on his website…. http://www.bencoles.co.uk/

Cheers,

Fabrication….the old school way …..

Manufacturing, the Old School way indeed and so refreshing to ses it here.
Long long may it live on!
Great thread, brilliant to see.

Distributor bodies now largely complete, other items off for heat treatment then onto assembly…..

I guess that often with these types of project things take a little longer than hoped……

….getting close now, moulds complete and ready for first casting……

I was asked if I had seen the centre lock spindles for 3.0 RSR, 935 etc that Ben produces as he hadn't seen them on his website yet?……

…..well he only produced them about 9-10 months ago so hasn't yet got around to advertising them! :rolleyes:…..but here's a few photos….









Cheers,

Small fan housing core boxes done….



…digging that part number! …..



Distributor spindles back from hardening this week and both projects should be complete by Christmas

Hot off the press......literally!

Aluminium test items that were cast this evening and are still warm!.........and in the words of Mr Coles 'look as rough as f***'.....a good thing as this replicates originals perfectly.

These aluminium castings are basically scrap and are used to test the moulds.....

....I think after a very short period of use these will be indistinguishable from original items.....that'll work for me! .......



...magnesium sand is finer so areas like the part number will be a little more defined....



.....the casts allow for the industry standard of 3mm machining on all machined surfaces and the front lip will end up thinner like the original....



.....

...150 hours of woodwork! ...



....and in time for Christmas!

Cheers,

Darren65 wrote: ....and in time for Christmas!

Well not quite...

....Christmas came and went...life and Honda work got in the way but the real issue that has slowed things down is that the part number for the magnesium fan housings just wasn't casting good enough....

....several attempts later with different moulds and the problem was solved...



....the good news is the moulds were taken to foundry this week for sixty castings to be made.....not all fan housings, Ben has also been asked to produce the oil thermostat/housing for 2.0L cars and the speedo drive for Carrera 4-cam engines (I think that's correct)....



....apparently the foundry Ben uses does some pretty good work, the job in line before Ben's was for Westland helicopter gearboxes .....



....nearly there!

The early twin sparks dizzies are complete and just waiting for assembly, will post a few final pics soon.

Cheers,

With my engine assembly fast approaching I've been hassling Ben to get my dizzy finished....

....this week he's been on the case...

https://www.youtube.com/watch?v=PtFtj6SzXKc

Looks very nice indeed

I think so as well Mark

Things looked pretty good when dyno tested too ......

https://www.youtube.com/watch?v=9IbtU3L ... e=youtu.be

Darren65 wrote:

markm wrote:So is Ben selling these repro dizzied Darren

For sure, he'll soon be adding these to the other parts for sale on his website…. http://www.bencoles.co.uk/

Cheers,

Some impressive work there (understatement!)

Is there a problem with Ben's Website Darren, the last few times I've tried I just get a blank page?

Cheers
Jon