I think R. design are much better quality than Dansk. OE...? Barry is probably the best person to answer that. No experience of there rear quarters as i used flares on my ST.
Apart from the quality of the steel, there is no backdating required on the restoration design parts. An important factor for the DIY route.
No making and fabricating complex indentations etc.
My two bobs worth. Enjoy Gary.
Dave
UK body panel supplies
-
stretch
- Me and DDK sitting in a tree! KISSING
- Posts: 2697
- Joined: Thu May 21, 2009 2:54 pm
- Location: Kent
Re: UK body panel supplies
70T barn find...... to ST.
1998 C2 996 Kettle
1998 C2 996 Kettle
-
Gary71
- Nurse, I think I need some assistance
- Posts: 10323
- Joined: Wed Mar 31, 2004 1:27 pm
- Location: Cheshire
- Contact:
Re: UK body panel supplies
Cheers Dave, I’m trying not to bother Barry anymore as I tapped enough of his brain at CLM!
-
Gary71
- Nurse, I think I need some assistance
- Posts: 10323
- Joined: Wed Mar 31, 2004 1:27 pm
- Location: Cheshire
- Contact:
Re: UK body panel supplies
Well. I've contacted Restoration Design Europe for a quote... Comes to about €2500 on the site once you've included all the other bits I didn't mention!
Other bits & 1/4s I'll source from Porsche once I've summoned the courage to ask how much!
Floor edges I'll get Dansk from the UK somewhere.
Cheers
Other bits & 1/4s I'll source from Porsche once I've summoned the courage to ask how much!
Floor edges I'll get Dansk from the UK somewhere.
Cheers