Hi,
Need some advice / recommendations as to who can bore out a set of plastic 'T' stacks that I have spare. I'd like to get them to 'S' specs. I'm doing this as I would like to get rid of the cold start spray (1970 design that sprays down into the trumpet), to the later design where the cold start fuel feeds further down the manifold.
Many thanks
MFI Stacks - converting a T Stack to 'S' specs
Moderators: hot66, impmad2000, Barry, Viv_Surby, Derek, Mike Usiskin
-
- Nurse, I think I need some assistance
- Posts: 16875
- Joined: Wed Nov 12, 2003 10:48 pm
- Location: Worcs/W Mids border
Re: MFI Stacks - converting a T Stack to 'S' specs
.
I had a couple of sets of 2.4E plastic stacks bored out to S/RS specs several years ago - but by Henry Schmidt at Supertec in the US.
In the UK the first suggestion that springs to mind is Neil Bainbridge ...
.
I had a couple of sets of 2.4E plastic stacks bored out to S/RS specs several years ago - but by Henry Schmidt at Supertec in the US.
In the UK the first suggestion that springs to mind is Neil Bainbridge ...
.
Andy
“Adding power makes you faster on the straights;
- subtracting weight makes you faster everywhere”
“Adding power makes you faster on the straights;
- subtracting weight makes you faster everywhere”
-
- Nurse, I think I need some assistance
- Posts: 18959
- Joined: Mon Mar 10, 2008 6:26 pm
- Location: West Midlands
Re: MFI Stacks - converting a T Stack to 'S' specs
Or maybe Greatworth classics, they have a nice machine shop with a good milling machine. Restore Webers too I think?
73T 911 Coupe, road/hillclimber 3.2L
Lola t 492 / 3.2 hillclimb racer
Boxster 987 Gen II 2.9
Lola t 492 / 3.2 hillclimb racer
Boxster 987 Gen II 2.9
Re: MFI Stacks - converting a T Stack to 'S' specs
Thank you all - will make contact with them