Hi,
Would anyone be able to make a part for the pedal assembly for a pedal car I'm restoring. Can send diagram across but in essence its a 8mm rod with 6mm threaded ends and a couple of small recesses for two circlips. rod will be approx 36cm long with 15mm of thread at each end.
Pedal car is a 1965 triang F1 car
appreciated any assistance
thanks
Danny
Part Fabrication - Pedal Car
Moderators: hot66, Miggs, 58A - 71E, impmad2000, drummerboytom, Barry, Helen, Viv_Surby, Derek, KS, abm914, Mike Usiskin
Part Fabrication - Pedal Car
1968 912
1970 Karmann Ghia
1960 LI 125 Lambretta
1970 Karmann Ghia
1960 LI 125 Lambretta
-
- Nurse, I think I need some assistance
- Posts: 19025
- Joined: Mon Mar 10, 2008 6:26 pm
- Location: West Midlands
Re: Part Fabrication - Pedal Car
Hello Danny
That is something I can do for you.
I have some black steel bar, exactly 360mm long (!)
Please pm a sketch esp detailing the circlip groove size and positions. I do not have any circlips though, but you can get them easy off ebay.
Please also pm an address I can post the rod to.
Regards, Graham.
That is something I can do for you.
I have some black steel bar, exactly 360mm long (!)
Please pm a sketch esp detailing the circlip groove size and positions. I do not have any circlips though, but you can get them easy off ebay.
Please also pm an address I can post the rod to.
Regards, Graham.
73T 911 Coupe, road/hillclimber 3.2L
Lola t 492 / 3.2 hillclimb racer
Boxster 987 Gen II 2.9
Lola t 492 / 3.2 hillclimb racer
Boxster 987 Gen II 2.9
Re: Part Fabrication - Pedal Car
Thanks Graham, will send details across via PM
Danny
Danny
1968 912
1970 Karmann Ghia
1960 LI 125 Lambretta
1970 Karmann Ghia
1960 LI 125 Lambretta
-
- Nurse, I think I need some assistance
- Posts: 19025
- Joined: Mon Mar 10, 2008 6:26 pm
- Location: West Midlands
Re: Part Fabrication - Pedal Car
Got it all, pm returned.
73T 911 Coupe, road/hillclimber 3.2L
Lola t 492 / 3.2 hillclimb racer
Boxster 987 Gen II 2.9
Lola t 492 / 3.2 hillclimb racer
Boxster 987 Gen II 2.9