Weber carb linkage wanted
Moderator: Miggs
-
- DDK Seasoned Poster
- Posts: 40
- Joined: Thu Apr 26, 2018 6:51 pm
Weber carb linkage wanted
Looking for the two side brackets with balls for the carb linkage cross piece,have the cross piece just need the two brackets which bolt to the inlet manifolds,also kn type filters and any rods too,thanks in advance 07831 678078.
Weber carb linkage wanted
Hey buddy are you interested in getting a nice Weber carb linkage it is available forsale at a cheaper rate not in any condition pm xxxxxxxxxxxxxxxx
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
-
- Nurse, I think I need some assistance
- Posts: 16928
- Joined: Wed Nov 12, 2003 10:48 pm
- Location: Worcs/W Mids border
Re: Weber carb linkage wanted
/\ /\ /\ /\
Beware - that's a scam (phishing) ...
.
Beware - that's a scam (phishing) ...
.
Andy
“Adding power makes you faster on the straights;
- subtracting weight makes you faster everywhere”
“Adding power makes you faster on the straights;
- subtracting weight makes you faster everywhere”
- Bootsy
- Site admin and the Boss
- Posts: 24005
- Joined: Sat Nov 08, 2003 6:09 pm
- Location: Norwich
- Contact:
Re: Weber carb linkage wanted
Scammer has been banned
1972 911T | 1994 993 Carrera | 1999 986 Boxster | 1990 T25 Camper
Vintage Heuer, Omega, Zenith and other vintage watches - http://www.heuerheritage.co.uk
Vintage Heuer, Omega, Zenith and other vintage watches - http://www.heuerheritage.co.uk
-
- DDK slapper chatter
- Posts: 404
- Joined: Sat May 23, 2009 7:30 pm
Re: Weber carb linkage wanted
pmeporsche,
I might have one or both of the cross pieces that bolt to the manifolds and perhaps some linkage bits. Will take a look and post again later today.
Edit: Found one of the cross pieces that bolt to the intake manifolds, a single intake manifold ( bored 40mm top/ 35mm bottom), some new weber carb jetting sets (a set of 135 main jets, and 55 idle jets) and a few other misc carb bits.
Feel free to pm me your email and I can send photos.
I might have one or both of the cross pieces that bolt to the manifolds and perhaps some linkage bits. Will take a look and post again later today.
Edit: Found one of the cross pieces that bolt to the intake manifolds, a single intake manifold ( bored 40mm top/ 35mm bottom), some new weber carb jetting sets (a set of 135 main jets, and 55 idle jets) and a few other misc carb bits.
Feel free to pm me your email and I can send photos.