ali rear licence plate panle

An archive of any Porsche 911 technical threads

Moderators: hot66, impmad2000, Barry, Viv_Surby, Derek, Mike Usiskin

Post Reply
ian cox
DDK slapper chatter
Posts: 338
Joined: Sat May 10, 2008 8:18 pm
Location: Berkshire

ali rear licence plate panle

Post by ian cox »

Hi,
Does anyone know the thickness of the aluminium plate used to make the rear licence plate panel on the 2.2 cars?
Regards Ian Cox
1969 2.2s restoration nearly complete
1972 911S/2.5ST replication (sold)
1985 3.2 carrera track day shed (sold)
Top
Lightweight_911
Nurse, I think I need some assistance
Posts: 16856
Joined: Wed Nov 12, 2003 10:48 pm
Location: Worcs/W Mids border

Re: ali rear licence plate panle

Post by Lightweight_911 »

I have one in the garage - will measure the thickness & post here later.
Andy

“Adding power makes you faster on the straights;
- subtracting weight makes you faster everywhere”
Top
Lightweight_911
Nurse, I think I need some assistance
Posts: 16856
Joined: Wed Nov 12, 2003 10:48 pm
Location: Worcs/W Mids border

Re: ali rear licence plate panle

Post by Lightweight_911 »

The panel I have is ~1mm thick - but it may not be typical as it's a Factory competition part.
Andy

“Adding power makes you faster on the straights;
- subtracting weight makes you faster everywhere”
Top
ian cox
DDK slapper chatter
Posts: 338
Joined: Sat May 10, 2008 8:18 pm
Location: Berkshire

Re: ali rear licence plate panle

Post by ian cox »

Hi,
Thanks very much.
Regards Ian Cox
1969 2.2s restoration nearly complete
1972 911S/2.5ST replication (sold)
1985 3.2 carrera track day shed (sold)
Top
Post Reply

Return to “Porsche 911 Technical Archive”