finally got the 912 in to the garage restoration starts here

owen nw · Post by **owen nw** » Sat Sep 25, 2010 10:38 am

a bit of dust removal , last bit of filling and priming done owen nw

owen nw · Post by **owen nw** » Sun Sep 26, 2010 4:14 pm

first build up coat came up very well all repairs turned out great , next is the turn of the van owen nw

couple of runs , but it has to be flattened agin for the final coats

owen nw · Post by **owen nw** » Thu Sep 30, 2010 6:26 pm

bumpers and number plate panel done , well all the filling , 2k primed flatted and base coated , next stone chip the inside of these then paint owen nw

owen nw · Post by **owen nw** » Fri Oct 01, 2010 6:09 pm

[IMG]http://i259.photobucket.com/albums/hh28 ... e209-1.jpg[/IMG

owen nw · Post by **owen nw** » Mon Oct 04, 2010 6:39 pm

to day it was the turn odf the wings , well one of them the worst one , which is still very good . i cut out the areas of rust cleaned everything back , then done some innner frame repairs first , when the inners were done i painted the insides , letting then dry while i made the repair panels , welded these on and , buffed down , flatten the pain over the wing and skimmed up . owen nw

owen nw · Post by **owen nw** » Mon Oct 04, 2010 6:43 pm

owen nw · Post by **owen nw** » Mon Oct 11, 2010 6:09 pm

now have the wing filled and done , until my great dane knocked it over so i had to stopper a few bits and prep the back side of the wing ,. now in red lead , just now to seam seal and stone chip before a colour coat is applied owen nw

Barry · Post by **Barry** » Tue Oct 12, 2010 7:25 pm

Well done, Owen: home straight now with the body by the looks of it.

I think it's a great credit to you, especially seeing the conditions in which you're working. It's a lovely stage when you realise that the colour sanding is out of the way, and all of a sudden the bodywork's done.

Best of luck with the last of the paint stages

.

owen nw · Post by **owen nw** » Tue Oct 12, 2010 8:01 pm

thanks barry , you have to work with what you ve got , when i have all the other panels done , i will fitt them , and flatt everything down with 600 wet dry , and prep for the final which will be done before xmas , again thank you owen nw

owen nw · Post by **owen nw** » Wed Oct 20, 2010 6:36 pm

wings in a coat of primer after wing number 2 has ahd its repair , well pleased with the result owen nw

owen nw · Post by **owen nw** » Sun Oct 24, 2010 4:20 pm

owen nw · Post by **owen nw** » Sun Oct 24, 2010 4:20 pm

owen nw · Post by **owen nw** » Wed Oct 27, 2010 11:48 am

might get a couple of reply s to this ?? front wings preped and in build up coat of yellow finished with the proper colour of yellow owen nw
build up coat

with gas blower going well