![Wink :wink:](./images/smilies/icon_wink.gif)
i have a 964 and the seals on the top of the front wing are shot. They've gone hard and crispy and the ends are shrinking inwards, so i decided to replace them.. I assumed (wrongly) that they would just be a push fit type seal, so imagine my surprise when I picked up the parts and they extend about 2" down between the pannels!..
I took a look at them over the weekend while I was replacing a couple of other seals around the bodywork, and can't decide how to get them out, unless I have to unbolt the wing. This stopped me in my tracks as I didnt want to undo the wrong bolt and then not be able to get the wing re-aligned again..
Are there any tips, tricks or inside knowledge you guys can impart on me that will help me replace these parts?.. Im assuming (again with the assumptions! ) that these seals are similar on most early 911/912 models so fingers crossed someone can help.
I have attached a couple of images below incase my description is rubbish, and await your collective wisdom!..
ben
![Image](http://www.smallspeed.co.uk/Image016.jpg)
![Image](http://www.smallspeed.co.uk/Image017.jpg)