How did you do it? rub the wood down and seal it with what? and paint the metal with what?
Pics look good
-Macs speed shop-
V dubs and Porsche tubs
87 924S (Now dead or is it?)
62 356 (Working on it!)
66 912 (Sadly gone - but have you seen the price of it!!)
Apal speedster (Sadly gone)
BSA Bantam in bits
A35 Race car in the making (peanutracing)
started by degreasing steering wheel then sanded back with 320 grade paper dry.
primed metal with etch primer allowed to tack off and primed with acrylic primer.
once thouroughly dry sanded again with 500 dry degreased tacked dust off and painted with simoniz satin black aerosol.
wood outer groove was cleaned up with a hacksaw blade to get a sharp edge.
degeased tacked off and laquered with high solid lechler dryed then sanded with 1000 paper wet laquered again this process was repeated till all imperfections were removed.
once dry flatted back with 1500 paper wet and polished with farecla g3
longwinded process but i think worth it .
ps if trying this it goes without saying wear an appropriate dust or paint mask.