These shims have been NLA for some time. Recently when pulling my car apart I noticed most of my camber adjustment had been made with washers. I knew I'd want to rectify this when I built the car again.
Tracing an original shim, I created an exact measured replica to a digital file and commissioned a few sets to be cut in mild steel.
As originally available I have produced them to replace the following part numbers.
91433153303 2mm
91433153304 3mm
91433153305 4mm
I'm only selling these as sets. Each set will contain 1 x 2mm, 1 x 3mm and 1 x 4mm.
£10 per set + p&p
914 Rear Alignment Shims
Moderator: Bootsy