DDK - Die Deutschen Klassiker

Yes, its a lightweight/GRP

Chris! Just what I was looking for, the black ones in the first pic..

How much will they cost?

Regards

That is, AMAZING!!

I came across a GRP RSR bumper without brackets...

Are the brackets a must or is there a way to mount it without them?

Are the brackets available in GRP? Not keen on cutting out originals..

Regards

Going!

I have never understood the "C" hype..

Seems like a lot of people test drive bad examples of whatever model and start picking on them, often bad mouthing "old technique" like the drum brakes...

Personally, I prefer an A but a T5B is a close second!

I am looking for 3 usable 2.2E Cyl head 46/40 valve diameter!

Anyone out there with some extra heads to part with?

Regards
Jesse

Thank you once again Chris! I really don't know what to believe anymore. It´s probably the human factor playing tricks over here..... Quick update on my car. Have been messing around with lots of other stuff but got time to install another set of original used 26mm torsion bars. Have been driving th...

Interesting..... New from Porsche before installation. Just 10 test miles or so.

I assume that the cracking paint is due to over stressed material but is has not broken into two pieces!

Lovely car!

I would not restore a car that nice.. There are too many restored 65's out there...

My advice would be to find someone who knows how to preserve a car.

Regards

Chris, I have tried to PM you on here before but no response. Tried email also!might have got caught in some spam filter?

Where should I contact you?

Regards
Jesse

Ok, a little update!

I reindexed the right hand side bar (again) took the car out for a spin and voila... Back where I started...

So, I would like to donate my RHS bar to science, any takers?

Thus im also in need of a good RHS 26mm torsion bar or a good, used set, anyone?

Regards
Jesse

Thank you Chris and others! The last thing I tested was to put liberal amounts of rubber grease on the new (ER) bushings in order to minimize sticking bushings. But, im open to your input! I had a vague memory of it being made out of one piece hence one side affecting the other which isnt my case.. ...

I have spent endless hours of work on my -71 911 with a sagging right rear.. Finally, after a long time of denial I measured the spring plate angle, set at 29 degrees and then drove the car hard and remeasured, now 23 degrees, riding on bump stops.... The spring plate splines look good, no sign of s...

Any updates on your issues?

Such a shame to see, really... Wonder where all the original parts end up!? On some R-clone perhaps...