DDK - Die Deutschen Klassiker

Is this 3 pin?

I have a good condition heater fan that sit on top off engine 100 pounds

I have a mounting bar which has 3 bolt holes that fit to a mounting bracket that receives it which has a rubber type mount for bar .I brought a rsr type bar before i realised which won't fit
Is there any advantages or disadvantages in using the rubber type ?

I'd like it

ive cleaned up pistons and barrels on the top of the piston is E on bottom 100p 36 + w6 +
on the cylinder there is a 1 then a 2 then a 5 in a triangle could any one tell me what the wear limits are on these

Cam timing is coming out at 4.2 and solex cams are 4.2 to.4 .6 do engine builders always stick to porsche set over laps ?

Not checked it yet 1 side is stripped. There was a electric fire over 1 side carbs were sent back to pmo to be rebuilt. So some was stripped by others but I want to go right though it

Managed to get picture on are these standard pistons?

HI Bob I take it you are trying to fit 964 pistons and cylinder to a 3.2, with the 3.2 heads, the 964 runs 11to1 CR with knock sensors, the CC of the 3.2 head is larger, I would have to check the CC of both heads to see the drop in CR if you are using the 964 cylinders, I take it you know the stud ...

Sorry I'm try to upload some pictures engine has been converted but awhile ago and I'm rebuilding it and want to check what's been done etc

Are these 100mm pistons standard 964 if so does any one know what compression ratio I should have .heads are 3.2 so is case with solex cams and pmo cards.

Interested in buying set up tools like sprocket alignment tool o ring tool . 100mm piston ring compressor etc

Are the studs still available and will they fit 76

Do you sell the steering rack end bushes if so could you give me a price.?

I would be interested in window rail would it fit 75 911