DDK - Die Deutschen Klassiker

Andrew, I have been told that the piston "only" rides / touches on the inner seal, hence as long as the surface does not have protruding highs (rust), then I think you should be fine with the caliper. The piston edge on the right appears damaged on your picture (which could potentially har...

Thanks, Mike! Exactly what I wanted to hear - from what I gather on the website, the 215 also fit 6" rim, so all good!

btw that is a stunning '73 Albert!! mine is a 73 (built Sept 72) in signal yellow that is currently undergoing major surgery

thread earmarked. just purchased the 123 bluetooth for my 2.4 so keen to hear how you get on with it.
Mine will get larger and higher compressed pistons, S-bored heads, E-cams and Webers. should be a fun combo

Dougal,

from the less experienced like me, a dumb question: can I fit on my (non-RS flared narrow-bodied) regular LWB car on my standard fuchs 15 x 6" in front the 185 and in the back the 215 without any rubbing (assuming std ride height) ?
Or are 215 too much for normal rear arches?

is it this one?
https://www.design911.com/p/porsche-911 ... 453190311/

just for clarification, it is NOT the aluminium plate on the front panel, they typically don't have rust issues

It's this one here:

Ok, thanks for all inputs. As I have all documents as well as the old piece in hand, I'll try my luck with my local P classic dealer. Based on your experience, would they stamp the piece (pior install) or prefer to stamp once fully on the chassis?

As part of my full restauration, I unfortunately need to get the front trunk vin plate redone. Whilst one can now buy this piece (official P-number 91150109800) from all major online stores (Design911, Rose P, etc.), I haven't had any luck finding someone who can actually stamp me the new piece, so ...

Thanks, Alastair - will pm you.

Looking for a engine cradle for my 911 engine (2.4 ltr) rebuild for purchase, or alternatively on loan.

Many thanks,
Martin

i'm interested in case the initial sell doesn't go through. thanks

pm sent

Replacing my bushings as part of a full rebuild. Looking for the ER tool - either to buy or to borrow (with deposit).
After several DIY fails, I'm looking for these two pieces:

Selling original dashboard defroster vent. Part no 911.552.411.00 Aluminium in very good condition, will need paint. 55gbp plus postage https://live.staticflickr.com/65535/51334540488_b338490e0f_b.jpg https://live.staticflickr.com/65535/51334326291_da8f76eeb8_b.jpg https://live.staticflickr.com/6553...

Selling entirely and original 1974 manual. Not a reprint, hard to find virgin. Considering it's age, in very good condition. No ripped pages, only dents. https://live.staticflickr.com/65535/51168870162_a634021169_c_d.jpg https://live.staticflickr.com/65535/51168873087_5b2b015252_c_d.jpg https://live...