DDK - Die Deutschen Klassiker

Having got the 2 battery boxes in my 69T I prefer to fit a larger single battery instead. Does anyone have the dimensions of one that is easily obtainable and if it proves to be a useable mod and is there anything else to think about ? I understand that there will be those who might remind me of the...

Thank you for your feedback, it fills in the gaps.

My 69T came with no brake callipers so I have acquired a set of 4 ATE callipers ( 3" bolt spacing ) complete with excellent ventilated discs. The callipers have an extra section in the middle to space them approx. 15mm more apart than the factory . The fronts are 48mm piston and the rears are 3...

thanks Lightweight it does seem that NGK are well liked by 911 owners.





Murray

Hi, looking for some advice for which spark plug options for a 69 911T please ? Same advice for a coil, leads and points ? Probably basic knowledge but slightly confusing as to makes and spec etc. Anyone running a Facet 12v cube pump ( type 40106 ) located in the front storage area or in the engine ...

Thank you all for your input, I will have my current pump checked but suspect that I will end up using a Facet in the engine compartment if only for ease of access

Thanks nine one one, the German site will not let me access its contents and the other one says " we do not have any sponsors for you ". Was it suppliers of the Facet pump that you were directing me to or alternative pumps and, if so please can you specify which pump ?

I was hoping to change my fuel pump on a 69 911T on Webers to one that could be mounted higher than the fuel tank in either the front or engine compartments. Facet say that their 12v Cube pump 40106 will be OK but I think that I would seek advice before I made that purchase.

Thank you in advance.

Thanks Andy.

Please can someone advise the size, pitch and length of both the front and rear calliper bolts for a 1969 911T ? Would also appreciate where to purchase those bolts ?

Thank you in advance.

Murray

thanks Richard, eBay seemed to list a full gasket / seal set but I could not locate the 2 green seals, I have sent design 911 a request .

Please can someone advise as to where to get the 2 oil cooler seals for a 1969 911T ? They are the square shouldered ones... normally green I believe ?

Thanks in advance.

Thank you for your comprehensive reply, I will check all of the carb numbers first so as to establish which model I have then check some jet sizes etc.

I have a pair of Weber 40 IDA triple choke carbs as std fitment on a 1969 911T and when buying new parts for rebuilding them please can someone advise as to whether the alternative 32 chokes and F24 emulsion tubes will make a noticeable difference if I fit them instead of 30 chokes and F26 emulsion ...

Thanks Andy, you are right ....that is probably what I remembered.