DDK - Die Deutschen Klassiker

Hello, I have been trying to fit the rear screen to my car (with a new seal and trim insert fitted). Using the string method, the window either sits too proud of the body/ the seal detatches itself from the trim insert/glass comes out of the seal (in the corner of the screen) or all of these!. Front...

where did you get yours from?

cheers,

Tony

Steve,

sounds like the same car - I live in Winchester.

Tony

Has anyone had any experience of the "123ignition" 356 distributor?

seems like a fair deal at around £200 - before I take the plunge I wondered if anyone had used one on their own car?

also the model shown is same as the VW one - is this just a fancy 009?

Cheers,

Tony

Steve,

You were right - an earth problem at the warning light end - all sorted now.

p.s do you own the 356 Tim Barnard was telling me about?

Cheers again,

Tony

Steve,

Thanks for your response - had the car a couple of years now and the problem is quite recent. Sorry didn't make that clear in my post.

everything was fine previously so a bit stumped..

Tony

Can anyone suggest a solution for the following? I have a US spec 356 C on 6 volt electrics and the indicators are playing up. the relay (under the dash which plugs into a dedicated point) looks original so I have tried two replacements - the first relay does nothing - the second puts the tell tale ...

Wanted moulded front luggage mat for 1964 356C coupe?

Anything out there?

Cheers,

Tony

Has anyone got a luggage mat for a 356C coupe at a reasonable price?

Thanks,

Tony

I am after a reasonably priced roof skin or roof panel for a 356 coupe.

Can anyone help?

Thanks,

Tony

fair points but the left hand on my car just won't adjust, I think due to an air leak, is slightly damaged and both are not fuel tight, which leads to fuel seepage onto the manifolds, despite two rebuilds - a bit of a concern on a run. I just want something new, which I feel will be safer in the lon...

Just got a pair of 40 IDFs for my 356 to repalce the zeniths it has at the moment. the manifold for the zeniths looks like it bolts down with one bolt - whilst the weber ones have a middle bolt and two (bolt) holes on the manifold flange? Will the weber manifold bolt down ok? Sorry if this is a dumb...

thanks for your help- much appreciated

4.5 inch rims

I have 1964 356C without a spare wheel and have been trying to fine one but no luck yet.

anyone know whether a standard porsche 944 wheel would have a suitable offset/be suitable?

otherwise any ideas where I might locate a spare?

thanks