Yes please Neil
Thanks for organising
Regards
sean
Search found 751 matches
- Tue Mar 26, 2024 5:35 pm
- Forum: Classic Porsche General Chat
- Topic: Stanford Hall Club Display Sunday 5 May
- Replies: 5
- Views: 144
- Mon Mar 18, 2024 7:01 pm
- Forum: Pre 1974 - Porsche 911 (longhood)
- Topic: Hazard Light - Control Light Relay 901.615.341.10
- Replies: 3
- Views: 100
Re: Hazard Light - Control Light Relay 901.615.341.10
I am thinking out loud here, but I think a flasher relay and two diodes on the output on the feeds to the indicators should work. Read it somewhere on the 912bbs. Or there is a VW flasher unit that works
Regards
Sean
Regards
Sean
- Sun Mar 10, 2024 9:18 am
- Forum: Porsche Restoration Threads
- Topic: USA 1970 911T - the Tangerine Dream
- Replies: 346
- Views: 53658
Re: USA 1970 911T - the Tangerine Dream
Looking good If you haven’t seen this thread before have a read https://www.ddk-online.com/phpBB2/viewtopic.php?t=28001&hilit=Sill+replacement These areas can end up being a lot of work! You may be lucky but until you have cleaned up the entire area fully you don’t know. There are at least three...
- Sat Mar 09, 2024 5:52 pm
- Forum: Porsche 912
- Topic: Stanford Hall
- Replies: 9
- Views: 369
Re: Stanford Hall
Could we make it a ddk display if we are doing it.
May have something else porche shaped to bring along
May have something else porche shaped to bring along
- Sat Feb 24, 2024 7:10 pm
- Forum: Classic Porsche General Chat
- Topic: The DDK Nationals
- Replies: 146
- Views: 4845
Re: The DDK Nationals
SeanP
North Essex
North Essex
- Sat Feb 24, 2024 7:07 pm
- Forum: Classic Porsche General Chat
- Topic: Your Porsche pic of the day......
- Replies: 28449
- Views: 1728121
Re: Your Porsche pic of the day......
Starting to look a little more finished when the badges go on!
Sent from my iPhone using Tapatalk
- Tue Feb 13, 2024 7:56 pm
- Forum: Pre 1974 - Porsche 911 (longhood)
- Topic: Alternator
- Replies: 10
- Views: 475
Re: Alternator
What is the make of the alternator? Bosch put out a different voltage to the SEV/Motorola type. The SEV regulator is rated at 14.5V the Bosch is lower at around 13.5V if I remember rightly. Do a test start and rev the car up above 2000 rpm measure the voltage and test again at idle. If there is no c...
- Sun Feb 11, 2024 2:50 pm
- Forum: Pre 1974 - Porsche 911 (longhood)
- Topic: 1970 - what's in this hole?
- Replies: 4
- Views: 355
Re: 1970 - what's in this hole?
It’s in there to trap moisture and not much else
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
- Sat Feb 10, 2024 6:35 pm
- Forum: Pre 1974 - Porsche 911 (longhood)
- Topic: 1970 - what's in this hole?
- Replies: 4
- Views: 355
Re: 1970 - what's in this hole?
The large hole?
Its for the latch bolt to go into when its adjusted
Its for the latch bolt to go into when its adjusted
- Sat Feb 10, 2024 11:24 am
- Forum: Pre 1974 - Porsche 911 (longhood)
- Topic: Engine mount
- Replies: 14
- Views: 503
Re: Engine mount
Karmann Konnection have one for sale
Phone them rather than do the eBay thing
Phone them rather than do the eBay thing
- Wed Feb 07, 2024 1:11 am
- Forum: Porsche 912
- Topic: Stainless Exhaust
- Replies: 10
- Views: 526
Re: Stainless Exhaust
Thanks gents. Is yours a standard design, Sean? Twin outlet with TT J pipes. Cut the heat exchangers open and installed the J pipes in them so I have heat. exhaust pipes are low enough to clear the bodywork and are not really obtrusive. Noise is not obtrusive on tick over but goes into a deep throa...
- Tue Feb 06, 2024 3:21 pm
- Forum: Porsche 912
- Topic: Stainless Exhaust
- Replies: 10
- Views: 526
Re: Stainless Exhaust
Have a TT exhaust on my 12 for the past few years
Worth the money.
fitted without issues.
Worth the money.
fitted without issues.
- Sun Feb 04, 2024 5:35 pm
- Forum: Pre 1974 - Porsche 911 (longhood)
- Topic: Outer sill top edge... cut off to replace sill?
- Replies: 10
- Views: 524
Re: Outer sill top edge... cut off to replace sill?
Normally just drill out the spot welds and brake the remaining weld with a panel splitting chisel. Once off straighten the edge out with a hammer and dolly. You then asses the state of everything. If the outer sill has rot then you can pretty much assume that the middle sill has rust including the j...
- Mon Jan 29, 2024 9:31 am
- Forum: Classic Porsche General Chat
- Topic: Glass cleaning
- Replies: 4
- Views: 277
Re: Glass cleaning
Diluted IPA? (Isopropyl Alcohol)
- Sun Jan 28, 2024 5:54 pm
- Forum: Classic Porsche General Chat
- Topic: Your Porsche pic of the day......
- Replies: 28449
- Views: 1728121
Re: Your Porsche pic of the day......
IMG_1230 by Sean Plumpton, on Flickr
How it started
IMG_4582 by Sean Plumpton, on Flickr
Where I am after 3 years!
How it started
IMG_4582 by Sean Plumpton, on Flickr
Where I am after 3 years!