DDK - Die Deutschen Klassiker

Hi Mike

Interested in the Weber Manifolds if you could post them

Regards

Sean

I have just replaced a set of URO ones after a year with Mayle 430N struts.
You take pot luck with what ever you buy

Interested
Hotel and dinner

Sean

Yes please Neil
Thanks for organising

Regards

sean

I am thinking out loud here, but I think a flasher relay and two diodes on the output on the feeds to the indicators should work. Read it somewhere on the 912bbs. Or there is a VW flasher unit that works

Regards

Sean

Looking good If you haven’t seen this thread before have a read https://www.ddk-online.com/phpBB2/viewtopic.php?t=28001&hilit=Sill+replacement These areas can end up being a lot of work! You may be lucky but until you have cleaned up the entire area fully you don’t know. There are at least three...

Could we make it a ddk display if we are doing it.
May have something else porche shaped to bring along

SeanP
North Essex

Starting to look a little more finished when the badges go on!


Sent from my iPhone using Tapatalk

What is the make of the alternator? Bosch put out a different voltage to the SEV/Motorola type. The SEV regulator is rated at 14.5V the Bosch is lower at around 13.5V if I remember rightly. Do a test start and rev the car up above 2000 rpm measure the voltage and test again at idle. If there is no c...

It’s in there to trap moisture and not much else


Sent from my iPhone using Tapatalk

The large hole?
Its for the latch bolt to go into when its adjusted

Karmann Konnection have one for sale
Phone them rather than do the eBay thing

Thanks gents. Is yours a standard design, Sean? Twin outlet with TT J pipes. Cut the heat exchangers open and installed the J pipes in them so I have heat. exhaust pipes are low enough to clear the bodywork and are not really obtrusive. Noise is not obtrusive on tick over but goes into a deep throa...

Have a TT exhaust on my 12 for the past few years
Worth the money.
fitted without issues.