DDK - Die Deutschen Klassiker

Have a pair of 8 x 15, offset is the same as the Fuchs wheels. PM me if you are interested in this size.

Keith

Hi,
Will take the £110 plastic airbox you have for sale if it is not damaged and not heat distorted. Not bothered by its cosmetic appearance, any more photos?
Keith

Removed the front suspension to replace the A-arm bushes at the weekend, and found severely corroded and pitted torsion bars!!!! Anybody got a pair in reasonable condition cluttering up their workshop or garage that they want to let go?? !9mm standard bars required, but might consider thicker if not...

Hi,

I have a working ecu which I removed from my car when I went to aftermarket ecu and ITB's.
Numbers on the case are,
TYP 911 MWS-01
Bosch 0261 200 078
911 618 111 13

Also have the full ecu harness, altitude module and dme relay if required.
pm me if interested.

Keith

Hi, I have an ecu part no. 911 618 111 13 / 0261 200 078 available, plus the harness from ecu to engine and fuse box, and the altitude module and DME relay. Also have the two speed pick ups. All taken from a running '84 or '85 engine used in my early car before converting to TB's and ecu several yea...

Thanks for the suggestions, guys. I just thought I would try here before ordering. I was aware of Eurocarb, a company called Classic Carbs and Webcon, but didn't realise SC stocked Weber parts - I have used them in the past for SU parts. I have also found a company called Eurospares who deal in Ferr...

I was stripping a set of carbs to clean and sheared the hex heads of two brass man jet holders, two float chamber plugs, and screwed up the slot in an air correction jet.

So, anyone have two main jet holders, two float chamber plugs and a 185 air correction jet spare and available?

Thanks,
Keit

Hi,

I have the complete body harness with plugs - from fuse block to ecu under seat to engine compartment.
Don't have the on engine harness to the injectors.
Also have an ECU and DME relay available if required and two sets of injectors.

Regards,
Keith

Hi Bootsy, Was hoping you would reply, I know that you have had a couple of these in the past. Don't know what happened with the photos, will try again. Thanks, Keith http://i305.photobucket.com/albums/nn205/74carrera/Heuer/PCx200151.jpg http://i305.photobucket.com/albums/nn205/74carrera/Heuer/P5200...

To refurbish or sell as is. As a non watch person, would appreciate some advice from you collectors and dealers of fine watches. I bought a Heuer Silverstone new in 1978 and proceeded to use it as my everyday (and only) watch for more than 12 years before relegating it to being used for holidays and...

Still looking for a single early center cap, condition immaterial as it will be refurbed.
Also still need the oil pressure sender adapter 18mm x 10 mm.
Anybody got either of these that they don't need?

I am looking for one early Fuchs centre cap. Condition not imprtant as it will be painted to match the others that I have. Even a damaged one may be ok as I can probably repair. Also need the 18mm x 10mm adapter that screws into the front of the block on top and accepts the oil pressure sender or sw...

I have three black plastic and three metal, Zenith carburettor velocity stacks, but would like a set of six all the same.

Anybody want to trade the three plastic stacks for metal ones??

Keith