DDK - Die Deutschen Klassiker

I tried this. Gave up in the end and drilled holes in the new paint. As nothing is straight it needs to be ‘pulled in’

Brave pill needed

Lots of grease on the holes, remove the swarf and I didn’t try too hard to secure the bottom edge so they can drain easily

Fingers crossed Mark

Close, but that’s a Rolls
And an electric one at that.

We do have one on the fleet and it’s most impressive even if it’s a BMW i7 underneath

Wow! Big day

Time for a new oil pump. They are expensive for sure, but so is doing all this again.

Best of luck

If you can get a set of three pistons off and then release half of the crankcase you can maybe get to whatever is jamming it, or to the other rod bolts and then it should come apart. Just put the engine stand connection on the side with the stuck pistons pointing towards the floor and leave the cran...

Out of all the 911s out there I think this one has had enough fuel flushed through it

bjmullan wrote:20 years ago you incorrectly introduce someone as a dentist and they are still taking the pi$$

Honestly I thought he was a dentist for a couple of years

That’s a real shame.
Good to narrow it down but a bummer when it turns out to be the complicated expensive bit.

Has it ‘lost’ the map?

Updates required. We are invested in this now!
You’ve been on it for hours… or have you sacked it off and gone to the pub…

Can you split a case without removing the pistons? Will the case move pass the stuck piston? Sent from my 22011119UY using Tapatalk Yes, but at this point you can pull the circlips out, knock the gudgeon pins through and pull them off. Possibly. The crank's at 90 degrees so some are alongside each ...

neilbardsley wrote:Can you split a case without removing the pistons? Will the case move pass the stuck piston?

Sent from my 22011119UY using Tapatalk

Yes, but at this point you can pull the circlips out, knock the gudgeon pins through and pull them off.

You’ve come this far. Finish the job

In for a penny…

All these years I’ve been getting my filings done by him.

It’s all a lie!

I’ve resisted for a while but I think we are at this point: